MODEL 46 HELP

Thread Rating:

1 Vote(s) - 3 Average
1
2
3
4
5

Linear Mode

MODEL 46 HELP

Radioroslyn
Phorum Expert

Posts: 7,285
Threads: 268
Joined: Dec 2009
City: Roslyn Pa

#18

03-24-2013, 04:12 PM

I would set up the tester for a 24A tube but set the heater voltage for 12.6v. I think this is going to be about as close as you are going get. The 14 tube I think was only used by Philco for a few early DC sets. Probably hard to find replacements.
Terry

Find

« Next Oldest | Next Newest »

Messages In This Thread

MODEL 46 HELP - by Bradley Rush - 03-12-2013, 03:01 PM

RE: MODEL 46 HELP - by codefox1 - 03-12-2013, 04:47 PM

RE: MODEL 46 HELP - by 7estatdef - 03-12-2013, 04:53 PM

RE: MODEL 46 HELP - by Ron Ramirez - 03-12-2013, 04:55 PM

RE: MODEL 46 HELP - by Bradley Rush - 03-12-2013, 05:57 PM

RE: MODEL 46 HELP - by Bradley Rush - 03-12-2013, 06:17 PM

RE: MODEL 46 HELP - by Ron Ramirez - 03-12-2013, 08:13 PM

RE: MODEL 46 HELP - by Bradley Rush - 03-13-2013, 08:17 PM

RE: MODEL 46 HELP - by Bradley Rush - 03-14-2013, 08:52 AM

RE: MODEL 46 HELP - by Raleigh - 03-14-2013, 12:04 PM

RE: MODEL 46 HELP - by Bradley Rush - 03-14-2013, 07:51 PM

RE: MODEL 46 HELP - by Raleigh - 03-15-2013, 02:06 AM

RE: MODEL 46 HELP - by Bradley Rush - 03-15-2013, 08:36 AM

RE: MODEL 46 HELP - by Bradley Rush - 03-19-2013, 01:20 AM

RE: MODEL 46 HELP - by Bradley Rush - 03-20-2013, 01:36 AM

RE: MODEL 46 HELP - by Ron Ramirez - 03-20-2013, 07:51 AM

RE: MODEL 46 HELP - by Bradley Rush - 03-24-2013, 03:00 PM

RE: MODEL 46 HELP - by 7estatdef - 03-24-2013, 04:12 PM

RE: MODEL 46 HELP - by Arran - 03-24-2013, 07:16 PM

RE: MODEL 46 HELP - by Bradley Rush - 03-24-2013, 08:54 PM

RE: MODEL 46 HELP - by Arran - 03-25-2013, 12:04 AM

RE: MODEL 46 HELP - by Bradley Rush - 03-25-2013, 02:44 AM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone, Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

Who's Online

There are currently 5166 online users. [Complete List]
» 1 Member(s) | 5165 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me