1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
38-116 died the 3rd time! Guidance Please?
BrendaAnnD
Phorum Expert
*****
Posts: 1,108
Threads: 89
Joined: Jun 2011
City: Tacoma State, Province, Country: Washington
#24

03-26-2013, 09:44 PM
At the input of the pi network, you'll see a "dirty" audio signal. It will still likely have some RF (455 KHz) in it. But, you should see some audio there. Since those micas are an easy 100pf value, I would just go ahead and replace them and the resistor (50K 1/4 watt would be fine). If you need them, I can send you a couple nice little 100pf disc caps.
Find
« Next Oldest | Next Newest »


Messages In This Thread
RE: 38-116 died! - by 7estatdef - 03-15-2013, 10:13 PM
RE: 38-116 died! - by BrendaAnnD - 03-15-2013, 10:23 PM
RE: 38-116 died! - by jerryhawthorne - 03-15-2013, 10:29 PM
RE: 38-116 died! - by jerryhawthorne - 03-16-2013, 08:59 PM
RE: 38-116 died! - by jerryhawthorne - 03-17-2013, 05:51 PM
RE: 38-116 died! - by morzh - 03-17-2013, 07:57 PM
RE: 38-116 died! - by jerryhawthorne - 03-17-2013, 08:28 PM
RE: 38-116 died! - by morzh - 03-17-2013, 09:07 PM
RE: 38-116 died! - by jerryhawthorne - 03-17-2013, 09:09 PM
RE: 38-116 died! - by morzh - 03-17-2013, 09:14 PM
RE: 38-116 died! - by jerryhawthorne - 03-17-2013, 09:45 PM
RE: 38-116 died! - by morzh - 03-17-2013, 10:00 PM
RE: 38-116 died! - by morzh - 03-17-2013, 10:12 PM
RE: 38-116 died! - by jerryhawthorne - 03-17-2013, 11:05 PM
RE: 38-116 died! - by morzh - 03-18-2013, 09:36 AM
RE: 38-116 died! - by jerryhawthorne - 03-18-2013, 02:35 PM
RE: 38-116 died! Oh no, died again. Help - by BrendaAnnD - 03-26-2013, 09:44 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

[-]
Who's Online
There are currently 5153 online users. [Complete List]
» 2 Member(s) | 5151 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration