1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Speaker plug rivets
jerryhawthorne
Phorum Expert
*****
Posts: 1,562
Threads: 56
Joined: Nov 2008
City: Sedona, AZ/Placentia/CA
#2

03-28-2013, 05:56 PM
Looking forward to the pics Mortz. My 111 has had in the past for some reason the speaker plug replaced. It was done by cutting off one from some other set with about 3" of wire sticking out and then connecting to the wires coming from the radio and taping with electrical tape. Looks ugly. I can see finding a couple of those rivets may be difficult.
Jerry
A friend in need is a pest!  Bill Slee ca 1970.
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
Speaker plug rivets - by morzh - 03-28-2013, 03:20 PM
RE: Speaker plug rivets - by jerryhawthorne - 03-28-2013, 05:56 PM
RE: Speaker plug rivets - by morzh - 03-28-2013, 08:42 PM
RE: Speaker plug rivets - by jerryhawthorne - 03-28-2013, 09:35 PM
RE: Speaker plug rivets - by Phlogiston - 03-29-2013, 01:27 AM
RE: Speaker plug rivets - by morzh - 03-29-2013, 10:46 AM
RE: Speaker plug rivets - by jerryhawthorne - 03-29-2013, 01:54 PM
RE: Speaker plug rivets - by Phlogiston - 03-29-2013, 02:36 PM
RE: Speaker plug rivets - by morzh - 03-29-2013, 02:44 PM
RE: Speaker plug rivets - by jerryhawthorne - 03-29-2013, 06:51 PM
RE: Speaker plug rivets - by morzh - 03-29-2013, 10:45 PM
RE: Speaker plug rivets - by jerryhawthorne - 03-30-2013, 03:00 PM
RE: Speaker plug rivets - by morzh - 03-30-2013, 03:57 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Need Help to ID this radio 11 tube Philco
Thank you. I went to your online library and found 2 schematics. I will download and compare to components!Ken D. — 06:31 PM
Need Help to ID this radio 11 tube Philco
It is a 16B tombstone.morzh — 06:13 PM
Zenith H725
David - sorry, I reread your post and finally saw THD - now the % figures make sense. Thanks for explaining. The PSU...EdHolland — 06:06 PM
Need Help to ID this radio 11 tube Philco
Hi Everyone, New member but have been reading this for awhile for tips! Vaccum tubes were before my time so bear with ...Ken D. — 06:03 PM
My Philco 37-116 Restore
Thank you MrFixR55, I appreciate your comments very much. I do not detect much hum if any so I will be staying with the ...dconant — 05:15 PM
My Philco 37-116 Restore
Hi DConant Yes, you can replace chokes with resistors.  You do stand the risk of increased hum.  the solution is to inc...MrFixr55 — 04:23 PM
Zenith H725
1.7-3.9 %, a modified Sine wave inverter is around 25%. Most generators from big box stores run 10% at a 50% load. What ...David — 04:06 PM
My Philco 37-116 Restore
I am having a heck of a time doing the alignment on the AM band. I can't seem to dial in the 1500 KC oscillator. I can h...dconant — 03:35 PM
Zenith H725
David - I think I understand but what units are you discussing (Low of 1.7, high of 3.9)? Budget constraints for Ham ...EdHolland — 01:43 PM
My Philco 37-116 Restore
You're doing great. I wish I could be more involved, but my mind is right now preoccupied with the reason I am here in ...morzh — 12:21 PM

[-]
Who's Online
There are currently 721 online users. [Complete List]
» 2 Member(s) | 719 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration