Philco 84-B Early Model

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco 84-B Early Model

philconerd
Member

Posts: 60
Threads: 14
Joined: Oct 2008
City: Pequot Lakes, MN

#14

04-05-2013, 06:53 PM

Terry, I just checked the radio as you suggested.

The volume control measures per spec.

Ant. to Gnd measures 9.6 ohms, so the Antenna Coil is good.

What I suspect is that part of the Oscillator Coil is open. It's located in that middle can on the chassis.

G.

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco 84-B Early Model - by philconerd - 03-28-2011, 12:00 PM

RE: Philco 84-B Early Model - by philconerd - 04-05-2013, 02:21 PM

RE: Philco 84-B Early Model - by 7estatdef - 04-05-2013, 03:42 PM

RE: Philco 84-B Early Model - by Jayce - 04-05-2013, 05:35 PM

RE: Philco 84-B Early Model - by philconerd - 04-05-2013, 06:53 PM

RE: Philco 84-B Early Model - by Ron Ramirez - 04-05-2013, 08:12 PM

RE: Philco 84-B Early Model - by 7estatdef - 04-05-2013, 10:59 PM

RE: Philco 84-B Early Model - by Jayce - 04-06-2013, 04:39 PM

RE: Philco 84-B Early Model - by philconerd - 04-07-2013, 07:10 PM

RE: Philco 84-B Early Model - by 7estatdef - 04-08-2013, 08:45 PM

RE: Philco 84-B Early Model - by philconerd - 04-10-2013, 03:30 PM

RE: Philco 84-B Early Model - by philconerd - 04-11-2013, 01:30 PM

RE: Philco 84-B Early Model - by 7estatdef - 04-12-2013, 05:54 PM

Re: Philco 34-B Early Model - by 7estatdef - 03-28-2011, 03:01 PM

Re: Philco 84-B Early Model - by philconerd - 03-28-2011, 05:41 PM

Re: Philco 84-B Early Model - by 7estatdef - 03-28-2011, 06:27 PM

Re: Philco 84-B Early Model - by TA Forbes - 03-28-2011, 09:35 PM

Re: Philco 84-B Early Model - by philconerd - 03-29-2011, 01:10 PM

Re: Philco 84-B Early Model - by 7estatdef - 03-29-2011, 06:11 PM

Re: Philco 84-B Early Model - by Jim Berg - 04-13-2011, 11:40 PM

Re: Philco 84-B Early Model - by retroradios - 04-17-2011, 07:07 PM

Re: Philco 84-B Early Model - by 7estatdef - 04-18-2011, 09:00 PM

View a Printable Version

Users browsing this thread: 6 Guest(s)

Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone, Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me