Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

49-905 Questions
#2

I never bothered too much about it. However I don't think you need to keep those lugs in the firts place. You won't be able to make the case the common nebgative again so you will have to drill another hole and thread the common negative wire through it. In the same fashion you can drill out the lugs and thread three wires through and then connect them to the caps' leads. Then you could care less about the resistance.

If you still want the lugs used, just moat each lug instead of trying to clean the whole thing.


Messages In This Thread
49-905 Questions - by klondike98 - 04-30-2013, 09:24 PM
RE: 49-905 Questions - by morzh - 04-30-2013, 10:01 PM
RE: 49-905 Questions - by klondike98 - 04-30-2013, 11:47 PM
RE: 49-905 Questions - by morzh - 05-01-2013, 10:42 AM
RE: 49-905 Questions - by klondike98 - 05-01-2013, 12:54 PM
RE: 49-905 Questions - by klondike98 - 05-01-2013, 11:52 PM
RE: 49-905 Question #3 - by klondike98 - 09-09-2013, 06:42 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
37-690 Bass Choke Replacement
Ah, now where to find one. I've into this before on smaller sets, I now recall. Hammond makes one that is only rated...Radiodial — 03:27 PM
Philco 38-7 Speaker
Ask the admins to put them together. As for the renaming, while inside the thread, you simply press "New reply&quo...morzh — 02:23 PM
37-690 Bass Choke Replacement
This is the parts catalog. 32-7528 choke is 65H, 10mA, 2,250 Ohm inductance. Find a suitable one.morzh — 02:18 PM
37-690 Bass Choke Replacement
While troubleshooting the no bass amplification issue, I think I found the culprit. The choke #104 is reading 164K ohms....Radiodial — 01:42 PM
Philco 60 Squealing
Your IF transformers are tuned to the resonant frequency they were designed for. When you observe the bell curve they di...RodB — 01:35 PM
identify very thin wire for replacement on 37-640
Thanks so much for your help!  I really could not have gotten this far without the kindness of you and other members.  T...georgetownjohn — 11:50 AM
Philco 38-7 Oscillation
Will do, thank you.tludka — 10:26 AM
Philco 38-7 Oscillation
As to your oscillation issue I would align the IF transformers. That may solve the problem. You also would want to check...Radioroslyn — 10:22 AM
Philco 38-7 Speaker
Thank you, I will check this out, I do have some shields I can place around the specific tubes. I searched the four que...tludka — 10:18 AM
Philco 38-7 Speaker
Also, check if any wires going to Grid Caps of the tubes that are supposed to be INSIDE of their respective shields (if ...morzh — 09:54 AM

[-]
Who's Online
There are currently 2369 online users. [Complete List]
» 3 Member(s) | 2366 Guest(s)
AvatarAvatarAvatar

>