1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Test Equipment
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
B&K RF Signal Generator Repair
BrendaAnnD
Phorum Expert
*****
Posts: 1,108
Threads: 89
Joined: Jun 2011
City: Tacoma State, Province, Country: Washington
#17

05-11-2013, 08:43 PM
Did you check them in or out of circuit? In-circuit checks are unreliable at best (unless you are using something like a Cricket to test actual function.)
Find
« Next Oldest | Next Newest »


Messages In This Thread
B&K RF Signal Generator Repair - by Eric Adams - 05-09-2013, 07:53 PM
RE: B&K RF Signal Generator Repair - by morzh - 05-09-2013, 08:03 PM
RE: B&K RF Signal Generator Repair - by morzh - 05-09-2013, 09:11 PM
RE: B&K RF Signal Generator Repair - by morzh - 05-10-2013, 09:00 AM
RE: B&K RF Signal Generator Repair - by morzh - 05-10-2013, 02:56 PM
RE: B&K RF Signal Generator Repair - by morzh - 05-10-2013, 08:35 PM
RE: B&K RF Signal Generator Repair - by morzh - 05-10-2013, 08:37 PM
RE: B&K RF Signal Generator Repair - by Arran - 05-10-2013, 09:10 PM
RE: B&K RF Signal Generator Repair - by morzh - 05-11-2013, 07:36 PM
RE: B&K RF Signal Generator Repair - by BrendaAnnD - 05-11-2013, 08:43 PM
RE: B&K RF Signal Generator Repair - by morzh - 05-11-2013, 09:15 PM
RE: B&K RF Signal Generator Repair - by morzh - 05-11-2013, 10:36 PM
RE: B&K RF Signal Generator Repair - by morzh - 05-11-2013, 11:02 PM
RE: B&K RF Signal Generator Repair - by morzh - 05-11-2013, 11:16 PM
RE: B&K RF Signal Generator Repair - by morzh - 05-12-2013, 08:40 PM
RE: B&K RF Signal Generator Repair - by morzh - 05-13-2013, 12:23 PM
RE: B&K RF Signal Generator Repair - by morzh - 05-15-2013, 01:36 PM
RE: B&K RF Signal Generator Repair - by morzh - 05-15-2013, 02:49 PM
RE: B&K RF Signal Generator Repair - by morzh - 05-16-2013, 09:34 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

[-]
Who's Online
There are currently 2638 online users. [Complete List]
» 3 Member(s) | 2635 Guest(s)
AvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Test Equipment