Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Thoughts on a McMurdo Silver Masterpiece VI Speaker
#69

I have yet another mess on my hands. I have a Scott AW23, which hasn't the tweets in it. I have two pair of the Scott tweets, but the cone is missing in one of them. So, there is a lady in this area who rebuilds speakers. I took the coneless speaker to her, and there doesn't seem to be a cone anywhere that comes close to the right one for replacement. They appear to be made by Jensen.

If push comes to shove, (and it's already about there), I can make a new voice coil for the fool thing. You'd think that, by this time in history, there could have been an infinite number of voice coil sizes used, but that doesn't seem to play out properly.


Messages In This Thread
RE: Thoughts on a McMurdo Silver Masterpiece VI Speaker - by Doug Houston - 05-29-2013, 12:36 AM



Users browsing this thread: 16 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>