Dial Apart on 34

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Dial Apart on 34

marty
Member

Posts: 240
Threads: 27
Joined: Jun 2013
City: Boulder, Colorado

07-01-2013, 11:21 PM

Hi All;
I have downloaded The information on Dial and replacing the Rubber "O" rings, but I am not that far along.. I want to get the Dial face off, so I don't break or crack it..
Also I see that ther are three soldered screws under the Chassis for the Variable Capacitor, and Four screws for the mechanical gearing mechanism.. What all needs to come off and is it in any order or preference ?? and I need to take off the Vairable Capacitor to get at all of the Rust on the top of the chassis.. I would love to take the coil cans off as well, but I don't think they come off.. Am I right about that ?? The top of the Chassis has some deep rust stains in many places on the top of it..
Also, I did order the Tubes that I need.. Two of each, type..
THANK YOU Marty

Find

« Next Oldest | Next Newest »

Thread Closed

Messages In This Thread

Dial Apart on 34 - by marty - 07-01-2013, 11:21 PM

RE: Dial Apart on 34 - by marty - 07-02-2013, 11:20 AM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 610B oscillator wiring
I don't know what you are referring to when you say "tube cathode ground". Ground is a connection to the chass...RodB — 05:56 PM
Zenith H725
Good points, Arran. I haven't encountered this problem with any other radio (all earlier vintages), so am learning here....EdHolland — 05:32 PM
Zenith H725
Ed; One thing that I will say about these is that Brand Z was considerate enough to make these mica caps easily acces...Arran — 02:34 PM
Philco 610B oscillator wiring
Do you know what run # your chassis is? It took me a while to find what you were basing updates/modification on as I did...Radioroslyn — 07:34 AM
Need to purchase some accessories for restoration of my Old Philco Radio
COLLEAGUES, Thank you all for such good and important suggestions as how to find good replacement parts. I will go fo...palonso — 07:05 AM
Zenith H725
Here's what the inside of AM IFT2 looked like, and the other pic shows the discs I made to take place of the mica and ke...EdHolland — 07:40 PM
Zenith H725
IF2 will need replacement caps. The arcing was severe enough that the mica is pitted and holed where the HT flashed over...EdHolland — 04:04 PM
My Philco 37-116 Restore
Measuring from center tap like the tube voltages show. Cap 127 is isolated from ground. Cap 127 shown in upper left of p...dconant — 08:05 AM
My Philco 37-116 Restore
Are you measuring relative to the centertap or the GND?morzh — 11:57 PM
Philco 610B oscillator wiring
Still not clear on the wiring interface between the 6A7 and oscillator. After refering to the available schematics and s...Tubester — 07:18 PM

Who's Online

There are currently 712 online users. [Complete List]
» 4 Member(s) | 708 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me