1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Poll: How much would you be willing to pay for a reproduction Philco escutcheon of this type? - You do not have permission to vote in this poll.
20.00
0%
0
0%
25.00
50.00%
3
50.00%
30.00
50.00%
3
50.00%
15.00
0%
0
0%
Not interested
0%
0
0%
* You voted for this item. Show Results

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Possible new reproduction Philco escutcheon?
zenith82
Junior Member
**
Posts: 30
Threads: 5
Joined: Oct 2005
#6

11-19-2005, 01:14 AM
I think replicating this grille would be an excellent idea. There were several models that used it, most of which are rather common and over half of which have warped or broken grilles. I know I've passed up at least a dozen of these sets which were otherwise nice because of the damaged grille.

I hope there's enough demand for Larry to start making them. I've obtained a few knobs from him in the past and his work is top notch.

Tom
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
[No subject] - by Guest - 11-18-2005, 01:04 AM
Plastic escutcheon - by bill T - 11-18-2005, 08:04 AM
[No subject] - by panther - 11-18-2005, 09:14 PM
[No subject] - by Ron Ramirez - 11-18-2005, 09:33 PM
[No subject] - by zenith82 - 11-19-2005, 01:14 AM
New escutcheons, etc. - by Doug Houston - 11-19-2005, 07:06 PM
[No subject] - by Guest - 11-23-2005, 10:49 PM
[No subject] - by Ron Ramirez - 12-13-2005, 01:04 AM
Re: Possible new reproduction Philco escutcheon? - by Guest - 08-08-2010, 03:05 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Restoration of the Canadian General Electric A-87
I also checked all the radio tubes on my Hickok 530 tube tester. The 5Z3 kenotron turned out to be faulty, all the other...RadioSvit — 08:02 AM
Restoration of the Canadian General Electric A-87
Well... While the varnish is drying up, I started repairing the chassis... Of course I started by replacing the pa...RadioSvit — 07:12 AM
Philco Model 38-7: what caps & resistors do fail typically?
Hello Martin, Welcome aboard our little community what great Model 38-7 Sincerely Richardradiorich — 12:30 AM
Philco Model 38-7: what caps & resistors do fail typically?
Welcome to the Phorum Martin. I count about 9 paper caps, the 3 electrolytic caps and 2-Y2 safety caps to replace th...RodB — 09:44 PM
Part numbers to model cross
Jim, We have this index put together by Dale Cook but I don't think that is quite what you are looking for. The Parts...klondike98 — 09:37 PM
Philco Model 38-7: what caps & resistors do fail typically?
Yep the dim bulb test is OK but I'd definitely replace all those electrolytics before I did it. Since those #47 conden...klondike98 — 09:18 PM
Philco 42-345 Restoration/Repair
The resistor is a 2.2 Meg, it was the last one I hadn't replaced. The broadcast is coming in after replacing it.osanders0311 — 09:09 PM
Philco 42-345 Restoration/Repair
What does the resistor measure? I think it should be 3.3 Meg. If the oscillator coil has continuity and the resistanc...RodB — 09:03 PM
Philco Model 38-7: what caps & resistors do fail typically?
Good idea to check the coils... then I'll get hold of an incadescent light bulb and see what happens when the unit is sw...Musaeum — 08:49 PM
Philco 42-345 Restoration/Repair
I have that same set, ain't too much shortwave I like anyway.....it is a good AM DX set. PaulPaul Philco322 — 08:32 PM

[-]
Who's Online
There are currently 1422 online users. [Complete List]
» 3 Member(s) | 1419 Guest(s)
AvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios