1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Mystery Cap in 42-327
Vic Gibson
Junior Member
**
Posts: 25
Threads: 5
Joined: Jul 2013
City: Adairsville, GA
#7

07-04-2013, 07:33 PM
Mondial - Really good thought on the 7B7s. I did replace the .2 mF with the wrapped coil wire - using a new .2 with a somewhat smaller diameter - so it may not be working as well as it should. There is a .05 bypass on the screens (no. 28). Anyway, tomorrow I will reinstall the IF transformer - probably wont change the 3000pF. Then I will try your idea with the .05 and I'll post again. Thanks.
Find
« Next Oldest | Next Newest »


Messages In This Thread
Mystery Cap in 42-327 - by Vic Gibson - 07-04-2013, 03:52 PM
RE: Mystery Cap in 42-327 - by BrendaAnnD - 07-04-2013, 04:42 PM
RE: Mystery Cap in 42-327 - by Vic Gibson - 07-04-2013, 04:50 PM
RE: Mystery Cap in 42-327 - by Mondial - 07-04-2013, 06:41 PM
RE: Mystery Cap in 42-327 - by Vic Gibson - 07-04-2013, 06:54 PM
RE: Mystery Cap in 42-327 - by Mondial - 07-04-2013, 07:06 PM
RE: Mystery Cap in 42-327 - by Vic Gibson - 07-04-2013, 07:33 PM
RE: Mystery Cap in 42-327 - by John R - 07-05-2013, 01:37 PM
RE: Mystery Cap in 42-327 - by Vic Gibson - 07-05-2013, 02:40 PM
RE: Mystery Cap in 42-327 - by Vic Gibson - 07-06-2013, 09:41 AM
RE: Mystery Cap in 42-327 - by John R - 07-06-2013, 11:44 AM
RE: Mystery Cap in 42-327 - by Vic Gibson - 07-06-2013, 04:33 PM
RE: Mystery Cap in 42-327 - by codefox1 - 07-06-2013, 07:15 PM
RE: Mystery Cap in 42-327 - by Vic Gibson - 07-20-2013, 03:22 PM
RE: Mystery Cap in 42-327 - by John R - 07-20-2013, 04:30 PM
RE: Mystery Cap in 42-327 - by Vic Gibson - 07-20-2013, 05:11 PM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

[-]
Who's Online
There are currently 2762 online users. [Complete List]
» 2 Member(s) | 2760 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration