Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Delco 32 volt console
#4

If it is a 32 volt set you may find it a disappointment performance wise given the small number of tubes, 32 volts was the plate and screen voltage as well. It looks like they used two power output tubes, probably 48s, to make up for the low B+ voltage somewhat, normally they would also add extra RF and IF amplifiers to help it out. The only 32 volt set that I saw in person was a post war set from the late 40s, I think it was a Sparton, it was identical to an AC/DC model of the same era other then the wiring and a large label on the back warning that it was a 32 volt only set, yes it had the typical "Hubble style" plug like a normal AC radio would have. By far most rural market sets in Canada used sets of A, B, and sometimes C batteries with the odd one using a 6 volt vibrator supply.
Unfortunately the garden variety battery sets were not immune from fools and other uninformed persons getting their hands on them, I have a Phonola downstairs where some idiot had twisted the remains of a molded plug on the end and tried plugging it in. I can't tell you how many I've seen where some dummy though it would be a good idea connecting one to a 12 volt car battery, if you are lucky enough they may have only tried connecting it to the B+ leads and only blew out the B- resistor
Regards
Arran


Messages In This Thread
Delco 32 volt console - by Jayce - 07-19-2013, 05:51 PM
RE: Delco 32 volt console - by Jayce - 07-19-2013, 09:44 PM
RE: Delco 32 volt console - by Arran - 07-20-2013, 02:01 AM
RE: Delco 32 volt console - by jerryhawthorne - 07-20-2013, 03:18 PM
RE: Delco 32 volt console - by Sean - 07-20-2013, 03:59 PM
RE: Delco 32 volt console - by Jayce - 07-20-2013, 05:09 PM
RE: Delco 32 volt console - by jerryhawthorne - 07-20-2013, 05:36 PM
RE: Delco 32 volt console - by Sean - 07-20-2013, 09:51 PM
RE: Delco 32 volt console - by Jayce - 07-21-2013, 04:48 PM
RE: Delco 32 volt console - by BrendaAnnD - 07-21-2013, 08:57 PM
RE: Delco 32 volt console - by Arran - 07-21-2013, 10:13 PM
RE: Delco 32 volt console - by codefox1 - 07-21-2013, 11:57 PM
RE: Delco 32 volt console - by BrendaAnnD - 07-22-2013, 01:51 AM
RE: Delco 32 volt console - by Jayce - 07-22-2013, 04:03 PM
RE: Delco 32 volt console - by Jayce - 09-23-2013, 09:50 PM
RE: Delco 32 volt console - by TA Forbes - 09-23-2013, 10:08 PM
RE: Delco 32 volt console - by BrendaAnnD - 09-23-2013, 11:26 PM
RE: Delco 32 volt console - by Arran - 09-24-2013, 12:51 AM
RE: Delco 32 volt console - by TA Forbes - 09-24-2013, 02:02 PM
RE: Delco 32 volt console - by marty - 09-24-2013, 02:20 PM
RE: Delco 32 volt console - by Jayce - 09-24-2013, 04:26 PM
RE: Delco 32 volt console - by marty - 09-24-2013, 05:07 PM
RE: Delco 32 volt console - by TA Forbes - 09-24-2013, 06:26 PM
RE: Delco 32 volt console - by Jayce - 09-24-2013, 07:56 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
[split] New member...
Well, with the replacement tuning assembly, I have finally put the unit back together and aligned the dial.  The first s...HowardWoodard — 01:01 AM
Philco Model 16 wiring question
Well, finding a short is easy. Like I said, disconnect the transformer's secondary windings and see if it persists. If...morzh — 09:48 PM
Restoring Philco 96
Nice one!Stan the Man — 09:37 PM
Restoring Philco 96
I have eventually replaced the speaker and shot the video, which only shows the upper part of the dial as the hum is ver...morzh — 09:24 PM
Rogers Majestic R-646
Kinda weird to see both open Nothing weird if you remember that this radio is about 100 years old  :)Vlad95 — 07:49 PM
Philco 42-345 Restoration/Repair
I believe I'm making progress, resistors have been rechecked and corrected, removed that ugly blue capacitor and more wi...osanders0311 — 07:38 PM
Philco Model 16 wiring question
Thanks Morzh Yes I recapped everything and replaced almost all the resistors as well. I redid #99 with .015 safety ca...bobclausen — 07:11 PM
Philco Model 16 wiring question
Well...pull out every single load of the transformer. For every winding. Unsolder if needed. Then re-do your dim bulb....morzh — 07:02 PM
Rogers Majestic R-646
Kinda weird to see both open, but once you get it up and running, really pay attention to your sound. Listen for loud cr...TV MAN — 06:59 PM
Rogers Majestic R-646
Vlad; I was just reminded of something else, I'm not sure why but many Rogers built sets do seem to have open primari...Arran — 04:40 PM

[-]
Who's Online
There are currently no members online.

>