Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 118 Dial Stringing
#7

It was the center hinged/levered fiber pulley that I removed. Going from the top to bottom pulleys was where I put the o-ring. It doesnt seem to matter for tuning that the center one is gone


Messages In This Thread
Philco 118 Dial Stringing - by davemc - 07-17-2013, 04:29 PM
RE: Philco 118 Dial Stringing - by Ron Ramirez - 07-17-2013, 04:31 PM
RE: Philco 118 Dial Stringing - by davemc - 07-18-2013, 01:30 PM
RE: Philco 118 Dial Stringing - by Ron Ramirez - 07-18-2013, 01:36 PM
RE: Philco 118 Dial Stringing - by SteveJB - 07-19-2013, 11:10 AM
RE: Philco 118 Dial Stringing - by davemc - 07-19-2013, 02:45 PM
RE: Philco 118 Dial Stringing - by SteveJB - 07-20-2013, 04:27 PM
RE: Philco 118 Dial Stringing - by davemc - 07-20-2013, 05:32 PM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM

[-]
Who's Online
There are currently 5717 online users. [Complete List]
» 1 Member(s) | 5716 Guest(s)
Avatar

>