Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

370 Chairside
#13

Txn for the details on the tone control. The first one I got a previous owner drill holes in the cabinet for the off/on sw and for the tone control so this didn't have wire job for the control. The other one I got a few months ago but haven't unpacked it so haven't looked it over. Interesting system for changing the tone!
Terry


Messages In This Thread
370 Chairside - by RoyG - 07-17-2013, 04:45 PM
RE: 370 Chairside - by 7estatdef - 07-17-2013, 05:53 PM
RE: 370 Chairside - by RoyG - 07-17-2013, 06:14 PM
RE: 370 Chairside - by jerryhawthorne - 07-17-2013, 07:18 PM
RE: 370 Chairside - by 7estatdef - 07-17-2013, 09:33 PM
RE: 370 Chairside - by Arran - 07-18-2013, 03:13 AM
RE: 370 Chairside - by Ron Ramirez - 07-18-2013, 05:30 AM
RE: 370 Chairside - by RoyG - 07-18-2013, 12:53 PM
RE: 370 Chairside - by Ron Ramirez - 07-18-2013, 12:54 PM
RE: 370 Chairside - by RoyG - 07-19-2013, 12:23 PM
RE: 370 Chairside - by klondike98 - 07-19-2013, 12:48 PM
RE: 370 Chairside - by jerryhawthorne - 07-19-2013, 02:12 PM
RE: 370 Chairside - by 7estatdef - 07-20-2013, 08:45 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM

[-]
Who's Online
There are currently 4111 online users. [Complete List]
» 3 Member(s) | 4108 Guest(s)
AvatarAvatarAvatar

>