1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Restoring a restored 39-6
Radioroslyn
Phorum Expert
*****
Posts: 7,285
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#2

07-22-2013, 08:51 AM
Good Morning and Welcome to the Phorum!
Well it's morning it Philly now. I would buy a parts set from you know where. It's a pretty common set so it should be too difficult to find one. Also you could post in the wanted section of the phourm.
Terry
Find
« Next Oldest | Next Newest »


Messages In This Thread
Restoring a restored 39-6 - by rworne - 07-22-2013, 02:51 AM
RE: Restoring a restored 39-6 - by 7estatdef - 07-22-2013, 08:51 AM
RE: Restoring a restored 39-6 - by rworne - 07-22-2013, 02:35 PM
RE: Restoring a restored 39-6 - by 7estatdef - 07-22-2013, 03:07 PM
RE: Restoring a restored 39-6 - by klondike98 - 07-22-2013, 03:37 PM
RE: Restoring a restored 39-6 - by rworne - 07-22-2013, 03:56 PM
RE: Restoring a restored 39-6 - by Mondial - 07-22-2013, 04:44 PM
RE: Restoring a restored 39-6 - by rworne - 07-22-2013, 08:47 PM
RE: Restoring a restored 39-6 - by BrendaAnnD - 07-22-2013, 09:20 PM
RE: Restoring a restored 39-6 - by rworne - 07-22-2013, 10:50 PM
RE: Restoring a restored 39-6 - by Arran - 07-23-2013, 12:47 AM
RE: Restoring a restored 39-6 - by Warren - 07-23-2013, 03:36 PM
RE: Restoring a restored 39-6 - by rworne - 07-23-2013, 06:49 PM
RE: Restoring a restored 39-6 - by Pappy B - 07-24-2013, 12:30 AM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration