38-12 Code 121 Tube Dilemma

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

38-12 Code 121 Tube Dilemma

Ron Ramirez
Silent Key

Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand State, Province, Country: Indiana

07-24-2013, 04:44 PM

If it has a 6A8, then somebody replaced the original 7-pin socket with an octal socket.

The 6A7 and 6A8 are electrically identical, but as mentioned above, the 6A7 requires a 7-pin standard socket, while the 6A8 requires an octal socket.

--
Ron Ramirez
Ferdinand IN

Find

« Next Oldest | Next Newest »

Messages In This Thread

38-12 Code 121 Tube Dilemma - by Buzz - 07-24-2013, 04:11 PM

RE: 38-12 Code 121 Tube Dilemma - by Ron Ramirez - 07-24-2013, 04:44 PM

RE: 38-12 Code 121 Tube Dilemma - by BrendaAnnD - 07-24-2013, 04:47 PM

RE: 38-12 Code 121 Tube Dilemma - by Ron Ramirez - 07-24-2013, 04:50 PM

RE: 38-12 Code 121 Tube Dilemma - by Buzz - 07-24-2013, 04:52 PM

RE: 38-12 Code 121 Tube Dilemma - by codefox1 - 07-24-2013, 08:08 PM

View a Printable Version

Users browsing this thread: 3 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online

There are currently 5783 online users. [Complete List]
» 2 Member(s) | 5781 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me