1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
46-480 Power Transformer Vibrates
codefox1
Silent Key
*****
Posts: 2,128
Threads: 18
Joined: Oct 2008
City: Merrick, Long Island, NY
#3

07-29-2013, 09:31 AM
Agree, sounds like a recap is needed. When transformers heat up a lot, sometimes the tar comes out and the the winding pack vibrates freely. If there is not a short in the windings, you can take the bells off, and repack. I've used Elmers followed with electrical tape on the outside of the winding pack to firm things up a bit more against the bells. Make sure all screws are tight as well.
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
46-480 Power Transformer Vibrates - by Pepperoni - 07-28-2013, 10:18 PM
RE: 46-480 Power Transformer Vibrates - by codefox1 - 07-29-2013, 09:31 AM
RE: 46-480 Power Transformer Vibrates - by EricS - 09-17-2013, 07:09 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 45L Initial Check Up
Hello, I am in the process of checking out a Philco 45L. My question is does this model suffer from the Philco coil r...dconant — 06:11 PM
Philco 42-345 Restoration/Repair
The 2 towns you mentioned "Frustrated" and "Give Up" are places we have all been. Relax, take 5, thi...Paul Philco322 — 03:23 PM
Philco 89 Code 123 Osc Coil
Thanks for posting that information!klondike98 — 03:14 PM
Philco 42-345 Restoration/Repair
From what I see is the blue cap was added by someone after the radio was sold presumably to replace cap 40A. I can't tel...RodB — 03:12 PM
Philco 42-345 Restoration/Repair
Correction My original picture shows #40 cap, blue cap and #42 resistor connected.osanders0311 — 02:23 PM
Philco 42-345 Restoration/Repair
Well guys I am stuck, frustrated and about ready to give up. For starters all I'm getting from the speaker is a humming ...osanders0311 — 02:17 PM
[split] New member...
Thanks.  I'll try that.HowardWoodard — 01:13 PM
[split] New member...
You may have to start further back with your signal injection at the IF signal grid, then tune the second IF transformer...RodB — 10:28 AM
[split] New member...
Well, with the replacement tuning assembly, I have finally put the unit back together and aligned the dial.  The first s...HowardWoodard — 01:01 AM
Philco Model 16 wiring question
Well, finding a short is easy. Like I said, disconnect the transformer's secondary windings and see if it persists. If...morzh — 09:48 PM

[-]
Who's Online
There are currently 964 online users. [Complete List]
» 3 Member(s) | 961 Guest(s)
AvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration