Philco 66

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco 66

gary rabbitt
Senior Member

Posts: 271
Threads: 12
Joined: Nov 2005
City: Nashville, TN

02-23-2008, 03:00 AM

Hi,

If I had to guess,

I think the "gabinet" (cabinet) " barniz" is Varnish perhaps?

And I think that "Termination" would refer to finish.

So, I think he's asking about the finish on the transformer or as before, the trim?

I know Bablefish can be far from the real translation, but gets you into the ballpark.
Gary.

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco 66 - by Mauricio - 02-17-2008, 05:55 PM

[No subject] - by Ron Ramirez - 02-17-2008, 06:06 PM

thank Rom, other question - by Mauricio - 02-18-2008, 11:56 AM

[No subject] - by Ron Ramirez - 02-22-2008, 08:05 PM

[No subject] - by gary rabbitt - 02-23-2008, 03:00 AM

for Rom - by Mauricio - 02-24-2008, 05:47 PM

[No subject] - by Ron Ramirez - 02-24-2008, 10:46 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM
Philco 6K7
The suppressor grid (if by G3 you mean the S) is usually at the Cathode potential, which in this caes is GND. I am not ...morzh — 05:10 PM
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM

Who's Online

There are currently 4956 online users. [Complete List]
» 2 Member(s) | 4954 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me