1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 90 Help Needed
morzh
Odobenus rosmarus
*****
Posts: 15,818
Threads: 554
Joined: Oct 2011
City: Jackson, NJ
#2

08-17-2013, 10:29 PM
I think there's a mistake. The place where this cap goes to that coil should be connected to a C+ or similar voltage and there is no dot there in the sch.

Second, this cap becomes thus a decoupling capacitor and I think 0.05uF / 450V will do just fine.
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 90 Help Needed - by Scott Fletcher - 08-17-2013, 04:54 PM
RE: Philco 90 Help Needed - by morzh - 08-17-2013, 10:29 PM
RE: Philco 90 Help Needed - by Ron Ramirez - 08-18-2013, 09:13 AM
RE: Philco 90 Help Needed - by Chuck Schwark - 08-20-2013, 09:56 AM
RE: Philco 90 Help Needed - by morzh - 08-20-2013, 02:59 PM
RE: Philco 90 Help Needed - by Scott Fletcher - 08-20-2013, 04:26 PM
RE: Philco 90 Help Needed - by morzh - 08-20-2013, 09:40 PM
RE: Philco 90 Help Needed - by marty - 08-20-2013, 09:54 PM
RE: Philco 90 Help Needed - by Mondial - 08-20-2013, 11:27 PM
RE: Philco 90 Help Needed - by Scott Fletcher - 08-21-2013, 04:30 PM
RE: Philco 90 Help Needed - by Mondial - 08-21-2013, 08:33 PM
RE: Philco 90 Help Needed - by Scott Fletcher - 08-24-2013, 05:08 PM
RE: Philco 90 Help Needed - by Scott Fletcher - 09-06-2013, 04:33 PM
RE: Philco 90 Help Needed - by BrendaAnnD - 09-06-2013, 04:42 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 7059 online users. [Complete List]
» 2 Member(s) | 7057 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration