Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

46-480 Power Transformer Vibrates
#14

Well so far I'm finding nothing in the audio circuit that's bad. No caps, resistors etc. The audio transformer resistance readings are per the Philco paperwork. I've never seen a speaker that was bad except for needing a recone but I'll check that too.

I did go back to page one of the Philco troubleshooting guide for this radio. This is the paperwork from Chuck Schwark.

Supposed to have a minimum of 50Kohms from B+ to chassis gnd. I have 22K. Paperwork says to check three capacitors for shorts or leakage. The E-caps and one bypass cap. The old ones were good. Four years old but I installed all new ones anyway. Still 22K from B+ to gnd.

Still pluggin' away.

Johnny

"It's Nice To Be Nice To The Nice"
Major Frank Burns Mash 4077th


Messages In This Thread
46-480 Power Transformer Vibrates - by Pepperoni - 07-28-2013, 10:18 PM
RE: 46-480 Power Transformer Vibrates - by Pepperoni - 08-23-2013, 05:48 PM
RE: 46-480 Power Transformer Vibrates - by EricS - 09-17-2013, 07:09 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 45L Initial Check Up
Hello, I am in the process of checking out a Philco 45L. My question is does this model suffer from the Philco coil r...dconant — 06:11 PM
Philco 42-345 Restoration/Repair
The 2 towns you mentioned "Frustrated" and "Give Up" are places we have all been. Relax, take 5, thi...Paul Philco322 — 03:23 PM
Philco 89 Code 123 Osc Coil
Thanks for posting that information!klondike98 — 03:14 PM
Philco 42-345 Restoration/Repair
From what I see is the blue cap was added by someone after the radio was sold presumably to replace cap 40A. I can't tel...RodB — 03:12 PM
Philco 42-345 Restoration/Repair
Correction My original picture shows #40 cap, blue cap and #42 resistor connected.osanders0311 — 02:23 PM
Philco 42-345 Restoration/Repair
Well guys I am stuck, frustrated and about ready to give up. For starters all I'm getting from the speaker is a humming ...osanders0311 — 02:17 PM
[split] New member...
Thanks.  I'll try that.HowardWoodard — 01:13 PM
[split] New member...
You may have to start further back with your signal injection at the IF signal grid, then tune the second IF transformer...RodB — 10:28 AM
[split] New member...
Well, with the replacement tuning assembly, I have finally put the unit back together and aligned the dial.  The first s...HowardWoodard — 01:01 AM
Philco Model 16 wiring question
Well, finding a short is easy. Like I said, disconnect the transformer's secondary windings and see if it persists. If...morzh — 09:48 PM

[-]
Who's Online
There are currently 967 online users. [Complete List]
» 2 Member(s) | 965 Guest(s)
AvatarAvatar

>