FM alignment

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

FM alignment

Mondial
Phorum Expert

Posts: 1,114
Threads: 14
Joined: Feb 2013
City: Irvington, NY

08-25-2013, 10:32 PM

No good. That one covers 8000 to 12400 MHz !

The HP 8620C is also a possibility but you need to make sure it has the low freq 1- 110 MHz plug in.

I would still recommend the 8601A. It is not only a sweep generator but also a calibrated output AM-FM signal generator, adjustable from 0.1 microvolt to 3 volts of RF output.

(This post was last modified: 08-25-2013, 10:33 PM by Mondial.)

Find

« Next Oldest | Next Newest »

Messages In This Thread

FM alignment - by Eric Adams - 08-25-2013, 05:10 PM

RE: FM alignment - by Mondial - 08-25-2013, 09:53 PM

RE: FM alignment - by Eric Adams - 08-25-2013, 10:05 PM

RE: FM alignment - by Eric Adams - 08-25-2013, 10:19 PM

RE: FM alignment - by Mondial - 08-25-2013, 10:32 PM

RE: FM alignment - by Eric Adams - 08-25-2013, 10:39 PM

RE: FM alignment - by Mondial - 08-25-2013, 10:52 PM

RE: FM alignment - by codefox1 - 08-25-2013, 11:31 PM

RE: FM alignment - by Eric Adams - 08-26-2013, 01:16 AM

RE: FM alignment - by Eric Adams - 08-27-2013, 09:23 AM

RE: FM alignment - by BrendaAnnD - 08-27-2013, 11:52 AM

RE: FM alignment - by Eric Adams - 08-27-2013, 01:05 PM

RE: FM alignment - by exray - 08-27-2013, 07:08 PM

RE: FM alignment - by Eric Adams - 08-27-2013, 09:01 PM

RE: FM alignment - by exray - 08-27-2013, 09:28 PM

RE: FM alignment - by Mondial - 08-27-2013, 09:39 PM

RE: FM alignment - by Eric Adams - 08-27-2013, 09:53 PM

RE: FM alignment - by Eric Adams - 08-29-2013, 08:45 PM

RE: FM alignment - by Mondial - 08-29-2013, 09:00 PM

RE: FM alignment - by Eric Adams - 08-29-2013, 09:09 PM

RE: FM alignment - by Eric Adams - 09-01-2013, 09:24 PM

RE: FM alignment - by Mondial - 09-01-2013, 10:01 PM

RE: FM alignment - by Eric Adams - 09-02-2013, 12:10 AM

RE: FM alignment - by BrendaAnnD - 09-02-2013, 04:10 AM

RE: FM alignment - by Eric Adams - 09-02-2013, 09:20 AM

RE: FM alignment - by Mondial - 09-02-2013, 01:44 PM

RE: FM alignment - by Eric Adams - 09-02-2013, 06:14 PM

RE: FM alignment - by Mondial - 09-02-2013, 07:24 PM

RE: FM alignment - by Eric Adams - 09-02-2013, 08:08 PM

RE: FM alignment - by Mondial - 09-02-2013, 08:42 PM

RE: FM alignment - by Eric Adams - 09-03-2013, 01:09 AM

RE: FM alignment - by Mondial - 09-03-2013, 11:16 AM

RE: FM alignment - by Eric Adams - 09-03-2013, 11:36 AM

View a Printable Version

Users browsing this thread: 22 Guest(s)

Recent Posts
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM
Philco 42-1008 conversion kit
I read about a kit to convert the variable speed changer in the Philco 42-1008 into a single speed unit. That would rem...alangard — 09:30 PM

Who's Online

There are currently 7530 online users. [Complete List]
» 1 Member(s) | 7529 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me