Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Maggy Concert Grand worth restoring??
#1

Just picked up a complete unit from about 1959 missing only the remote transmitter. Has mostly original Maggy tubes. Radio chassis works great. Only thing done to it was the filter cap replaced earlier by someone else. Tuning dial pointer motor works just fines and reverses. Motor on volume pot has open coil. I would like to find a replacement, but without the remote transmitter it would do no good. Would also like to find a replacement for the transmitter. These are probably fairly scarce, although with the way the amps are usually parted out, maybe there will be receiver chassis and transmitter sitting around collecting dust somewhere?? I hope!!
I have not yet fired up the two 12 tube power amps, but do not anticipate any problems. Will, of course, do so slowly, etc. Any comments welcome from others who may have had previous experience with these.


Messages In This Thread
Maggy Concert Grand worth restoring?? - by Harry - 08-27-2013, 02:56 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Zenith H725
I just remembered, I have some hi temp silicone rubber material which could do the trick. Or a piece of FR4 laminate. Th...EdHolland — 08:39 PM
Zenith H725
The PSU filter cap arrived today (thank you USPS!) so I will work on that later. Meanwhile, I have the dial, speaker...EdHolland — 06:42 PM
Philco 610B oscillator wiring
Thanks Terry. After checking my notes I think I recorded about -10v at the 6A7 G4/control grid. The screen grid (G3 &...Tubester — 05:59 PM
The list of my radio & TV collection!
Magical chords of forgotten melodies, old nostalgic music on an old radio... Saturday night blues on the Mid-Waves on an...RadioSvit — 12:20 PM
Philco 42-345 Restoration/Repair
Thank you MrFixr55 the issue with this radio is that the internal coil antenna is missing and there was a wire in its pl...osanders0311 — 11:34 AM
Philco 610B oscillator wiring
Regarding the oscillator circuit which is comprised of the 6A7's cathode, control grid, and screen grid. These elements ...Radioroslyn — 10:33 AM
Philco 42-345 Restoration/Repair
Hi OSanders, First off, welcome to the Philco Phorum where Phine Phamily-Phriendly Pholks Phull of Philco Phacts and P...MrFixr55 — 08:41 AM
Philco 42-345 Restoration/Repair
Today I've been reading through the site trying to learn more about this radio. I also soldered the lose power cord cabl...osanders0311 — 08:24 PM
Philco 610B oscillator wiring
Thanks David! I do have that same later prodution model 610 schematic. I've also studied the Philco service bulletins fo...Tubester — 08:12 PM
Philco 610B oscillator wiring
Some info from Beitmans says late production. David   David — 06:06 PM

[-]
Who's Online
There are currently 2274 online users. [Complete List]
» 1 Member(s) | 2273 Guest(s)
Avatar

>