1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
philco 37-630 no sound
Chuck Schwark
Phorum Expert
*****
Posts: 1,703
Threads: 55
Joined: Sep 2005
City: Evanston, IL
#13

09-03-2013, 09:01 AM
Also check to open RF, ant, osc and IF coils. Philco's notorious for corroded copper wire at terminals and/or in the windings themselves.

Chuck
Chuck Schwark,
The Philco Repair Bench
[Image: http://www.philcorepairbench.com/images/philog3tiny.gif]
http://www.philcorepairbench.com
Website Find
« Next Oldest | Next Newest »


Messages In This Thread
philco 37-630 no sound - by murf - 09-01-2013, 04:02 PM
RE: philco 37-630 no sound - by Phlogiston - 09-01-2013, 04:37 PM
RE: philco 37-630 no sound - by murf - 09-01-2013, 05:01 PM
RE: philco 37-630 no sound - by Jamie - 09-01-2013, 05:50 PM
RE: philco 37-630 no sound - by murf - 09-01-2013, 06:58 PM
RE: philco 37-630 no sound - by exray - 09-01-2013, 07:17 PM
RE: philco 37-630 no sound - by murf - 09-01-2013, 09:26 PM
RE: philco 37-630 no sound - by Jamie - 09-01-2013, 09:49 PM
RE: philco 37-630 no sound - by Phlogiston - 09-01-2013, 10:10 PM
RE: philco 37-630 no sound - by Mondial - 09-01-2013, 10:26 PM
RE: philco 37-630 no sound - by Groundhog74 - 09-03-2013, 07:10 AM
RE: philco 37-630 no sound - by Chuck Schwark - 09-03-2013, 09:01 AM
RE: philco 37-630 no sound - by marty - 09-03-2013, 09:46 AM
RE: philco 37-630 no sound - by murf - 09-03-2013, 10:16 AM
RE: philco 37-630 no sound - by Jamie - 09-03-2013, 10:44 AM
RE: philco 37-630 no sound - by Mondial - 09-03-2013, 11:00 AM
RE: philco 37-630 no sound - by Jamie - 09-03-2013, 12:25 PM
RE: philco 37-630 no sound - by Steve Davis - 09-03-2013, 02:44 PM
RE: philco 37-630 no sound - by morzh - 09-03-2013, 03:12 PM
RE: philco 37-630 no sound - by murf - 09-03-2013, 05:48 PM
RE: philco 37-630 no sound - by Tom Hamilton - 09-05-2013, 10:16 AM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration