push pull vs single ended

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

push pull vs single ended

marty
Member

Posts: 240
Threads: 27
Joined: Jun 2013
City: Boulder, Colorado

09-03-2013, 12:46 PM

Hi All;
I am going to repeat my question that I stated in my wanted philco 45 audio transformer section, just in case It did not get noticed..
Can a Push-pull Transformer be used in a Single ended transformers place ?? If the impedence matches..
Or is the windings on the push-pull transformer on each side wound opposite of each other ??
I can get a universal push-pull transformer that matyches my impedience for my 42 tube, but not a single ended transformer that will match perfectly its impedence..
THANK YOU marty

Find

« Next Oldest | Next Newest »

Messages In This Thread

push pull vs single ended - by marty - 09-03-2013, 12:46 PM

RE: push pull vs single ended - by codefox1 - 09-03-2013, 02:06 PM

RE: push pull vs single ended - by marty - 09-03-2013, 04:29 PM

RE: push pull vs single ended - by morzh - 09-03-2013, 09:04 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Made mistake & did not label connection
Hello John, I have been there either label got lost or was not labeled ! Sincerely Richardradiorich — 02:15 PM
Made mistake & did not label connection
Sorry, it is a Philco 37-640. Does that help?--Johngeorgetownjohn — 02:14 PM
two videos to watch VHS and history of TV
Hello Every, Here are a couple videos right up my alley VHS and the history of Television . history of VCR VHS Hi...radiorich — 02:13 PM
Made mistake & did not label connection
You haven't given us the model number of the set so I looked up the 6A8 pin assignment. Pin 8 is the cathode and pin 7 i...RodB — 01:19 PM
Made mistake & did not label connection
Happy Thanksgiving all! I have made a real bonehead mistake this time. Hope someone can help. I am trying to determi...georgetownjohn — 12:51 PM
New Philco Repair Bench
Apparently there is a new Philco Repair Bench found at https://philcoradio.com/repairbench/ When I try to go to order a ...dconant — 12:00 PM
Philco 60 Squealing
Well, a wave trap is a trimmer in series with the coil so at the resonant frequency it provides a short to ground. This ...RodB — 10:07 AM
Philco 60 Squealing
Rod, My radio is run 7. The wave trap is on that schematic as shown in the picture. dconant — 09:21 AM
American Bosch Model 802 auto radio
Hi Arran , Thanks for your help with this radio.And especial thanks for letting me know to look it up under United Ame...Antipodal — 04:32 AM
Philco 60 Squealing
Usually a wave trap is for keeping IF signals from entering the antenna and from leaving the antenna. You feed an IF sig...RodB — 09:30 PM

Who's Online

There are currently 2033 online users. [Complete List]
» 2 Member(s) | 2031 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me