Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

New and lost. 40-190
#6

What I do is when I'm recaping I;'ll break out the ohm meter and check the resistors has I go. You will notice that in a lot of cases there is a cap with a resistor wired across it. If you try to measure it without disconnecting it you won't get a proper reading. So when the cap comes out the meter goes in. The micas I leave alone till troubleshooting.
Your mileage my vary.
Terry


Messages In This Thread
New and lost. 40-190 - by Fibber Mcgee - 09-09-2013, 03:12 AM
RE: New and lost. 40-190 - by Radioroslyn - 09-09-2013, 07:29 AM
RE: New and lost. 40-190 - by jerryhawthorne - 09-09-2013, 12:55 PM
RE: New and lost. 40-190 - by EricS - 09-09-2013, 05:39 PM
RE: New and lost. 40-190 - by Fibber Mcgee - 09-10-2013, 12:22 AM
RE: New and lost. 40-190 - by Radioroslyn - 09-10-2013, 07:10 AM
RE: New and lost. 40-190 - by fossilexpress - 09-11-2013, 10:02 PM
RE: New and lost. 40-190 - by jerryhawthorne - 09-12-2013, 12:23 AM
RE: New and lost. 40-190 - by Fibber Mcgee - 09-13-2013, 05:13 PM
RE: New and lost. 40-190 - by jerryhawthorne - 09-13-2013, 05:48 PM
RE: New and lost. 40-190 - by marty - 09-13-2013, 06:33 PM



Users browsing this thread: 8 Guest(s)
[-]
Recent Posts
Made mistake & did not label connection
What does the dotted line representing that surrounds the tube in the schematic?georgetownjohn — 02:17 PM
Made mistake & did not label connection
Hello John, I have been there either label got lost or was not labeled ! Sincerely Richardradiorich — 02:15 PM
Made mistake & did not label connection
Sorry, it is a Philco 37-640.  Does that help?--Johngeorgetownjohn — 02:14 PM
two videos to watch VHS and history of TV
Hello Every, Here are a couple videos right up my alley VHS and the history of Television . history of VCR VHS Hi...radiorich — 02:13 PM
Made mistake & did not label connection
You haven't given us the model number of the set so I looked up the 6A8 pin assignment. Pin 8 is the cathode and pin 7 i...RodB — 01:19 PM
Made mistake & did not label connection
Happy Thanksgiving all! I have made a real bonehead mistake this time. Hope someone can help.  I am trying to determi...georgetownjohn — 12:51 PM
New Philco Repair Bench
Apparently there is a new Philco Repair Bench found at https://philcoradio.com/repairbench/ When I try to go to order a ...dconant — 12:00 PM
Philco 60 Squealing
Well, a wave trap is a trimmer in series with the coil so at the resonant frequency it provides a short to ground. This ...RodB — 10:07 AM
Philco 60 Squealing
Rod, My radio is run 7. The wave trap is on that schematic as shown in the picture. dconant — 09:21 AM
American Bosch Model 802 auto radio
Hi Arran ,  Thanks for your help with this radio.And especial thanks for letting me know to look it up under United Ame...Antipodal — 04:32 AM

[-]
Who's Online
There are currently 5383 online users. [Complete List]
» 1 Member(s) | 5382 Guest(s)
Avatar

>