O man now I've done it, Philco 37-116
Posts: 162
Threads: 37
Joined: Oct 2012
City: St Louis MO USA
All of the Bakelite blocks have been restuffed with the correct caps and any block that had resistors attached have also Been replaced. We tested the resistors and even if they were within tolerance we replaced them with the correct value. All of the electolytics have been replaced. The radio was tested after each block was stuffed too of course check for problems, none so far and the radio performance has improved . That takes care of the power unit and most of the I.F. Unit. Still have to replace the two .1 caps and the one .8 cap in the I.F. Unit then it's on to the infamous R.F.& Audio section but hey we're almost two thirds of the way.
Messages In This Thread
RE: O man now I've done it, Philco 37-116 - by Ronin61 - 09-11-2013, 06:17 PM
Users browsing this thread: 19 Guest(s)
|
Recent Posts
|
HiFi (Chifi) tube amp build - but my own design.
|
And so does a barber shop quartet. mmmmmmRodB — 03:54 PM |
Shadow Meter Bulb
|
I did try an LED bulb in place of the original but wasn't impressed with the amount of light on the dial. Seems like it ...RodB — 03:51 PM |
HiFi (Chifi) tube amp build - but my own design.
|
Tim
Would mounting he transformer vertically change the hum, if used without additional parts?
Also, in these amps...morzh — 02:25 PM |
Shadow Meter Bulb
|
Gary
I doubt it would introduce any noise. We use similar lamps for the panel indication, 12V AC lamps: they are LEDs...morzh — 02:15 PM |
Shadow Meter Bulb
|
Not sure if anyone has tried this but there are 6.3 volt miniature lamps in bayonet and screw-in base options available ...GarySP — 11:31 AM |
Shadow Meter Bulb
|
Any 6.3 volt pilot light will work. I would use the brightest one I could find in my workroom. Be sure the dial is clean...RodB — 10:45 AM |
HiFi (Chifi) tube amp build - but my own design.
|
Tim,
nice write up and thanks for sharing !!
Sincerely Richardradiorich — 02:47 AM |
HiFi (Chifi) tube amp build - but my own design.
|
Well, this was a real "Hum-Dinger" :lol: ! This will be kinda long, but hopefully it will help others having t...TV MAN — 01:55 AM |
Shadow Meter Bulb
|
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM |
Philco 41-608 changer coupler
|
3D-printing...short of machining, of course.
Or molding.morzh — 05:20 PM |
Who's Online
|
There are currently no members online. |
|
|