1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
New and lost. 40-190
jerryhawthorne
Phorum Expert
*****
Posts: 1,562
Threads: 56
Joined: Nov 2008
City: Sedona, AZ/Placentia/CA
#11

09-13-2013, 05:48 PM
Fibber, those wires from the push buttons carry very little voltage, if they are half way good, I would not play with them. Typically (not certain on your radio) they hang out there in the air far from anything they could short to. Keep in mind, I'm somewhat of a dim bulb.Icon_crazy Mostly cosmetic in that area just in case you wish to pull the radio out of the cabinet so friends can take a look.
Jerry
A friend in need is a pest!  Bill Slee ca 1970.
Find
« Next Oldest | Next Newest »


Messages In This Thread
New and lost. 40-190 - by Fibber Mcgee - 09-09-2013, 03:12 AM
RE: New and lost. 40-190 - by Radioroslyn - 09-09-2013, 07:29 AM
RE: New and lost. 40-190 - by jerryhawthorne - 09-09-2013, 12:55 PM
RE: New and lost. 40-190 - by EricS - 09-09-2013, 05:39 PM
RE: New and lost. 40-190 - by Fibber Mcgee - 09-10-2013, 12:22 AM
RE: New and lost. 40-190 - by Radioroslyn - 09-10-2013, 07:10 AM
RE: New and lost. 40-190 - by fossilexpress - 09-11-2013, 10:02 PM
RE: New and lost. 40-190 - by jerryhawthorne - 09-12-2013, 12:23 AM
RE: New and lost. 40-190 - by Fibber Mcgee - 09-13-2013, 05:13 PM
RE: New and lost. 40-190 - by jerryhawthorne - 09-13-2013, 05:48 PM
RE: New and lost. 40-190 - by marty - 09-13-2013, 06:33 PM



Users browsing this thread: 8 Guest(s)
[-]
Recent Posts
Made mistake & did not label connection
I was correct with the 6A8 pin connection's, 7 and 8 are connected to ground as well as the tube shield (the broken line...RodB — 02:41 PM
Made mistake & did not label connection
What does the dotted line representing that surrounds the tube in the schematic?georgetownjohn — 02:17 PM
Made mistake & did not label connection
Hello John, I have been there either label got lost or was not labeled ! Sincerely Richardradiorich — 02:15 PM
Made mistake & did not label connection
Sorry, it is a Philco 37-640.  Does that help?--Johngeorgetownjohn — 02:14 PM
two videos to watch VHS and history of TV
Hello Every, Here are a couple videos right up my alley VHS and the history of Television . history of VCR VHS Hi...radiorich — 02:13 PM
Made mistake & did not label connection
You haven't given us the model number of the set so I looked up the 6A8 pin assignment. Pin 8 is the cathode and pin 7 i...RodB — 01:19 PM
Made mistake & did not label connection
Happy Thanksgiving all! I have made a real bonehead mistake this time. Hope someone can help.  I am trying to determi...georgetownjohn — 12:51 PM
New Philco Repair Bench
Apparently there is a new Philco Repair Bench found at https://philcoradio.com/repairbench/ When I try to go to order a ...dconant — 12:00 PM
Philco 60 Squealing
Well, a wave trap is a trimmer in series with the coil so at the resonant frequency it provides a short to ground. This ...RodB — 10:07 AM
Philco 60 Squealing
Rod, My radio is run 7. The wave trap is on that schematic as shown in the picture. dconant — 09:21 AM

[-]
Who's Online
There are currently 6155 online users. [Complete List]
» 1 Member(s) | 6154 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration