1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 45 squeels
marty
Member
***
Posts: 240
Threads: 27
Joined: Jun 2013
City: Boulder, Colorado
#5

09-15-2013, 11:42 PM
Hi All;
Thank You all for Your responses..
Brenda Ann, and Vinzer, I have all of the Tube Shields in place.. I don't know If they are all Grounded.. But, they are all there..
How would I know If I have a Bad Bypass Cap, with out re-placing all of the Caps again ??
The One set of Caps that have Not been Replaced are C22, a pair of .09's in a Block, and the Caps in the Tone Control..
I have a Signal Generator, But not a low enough frequency Sweep Generator, the one Sweep Generator I have is for TV's, an Eico 369..
Radioroslyn, I know what a Sweep Generator is, I just don't have anything in the Radio Frequency Range.. And If needed be I could build the circuit using Ic's for almost nothing, hence Why I mentioned it..
THANK YOU Marty
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
Philco 45 squeels - by marty - 09-15-2013, 05:56 PM
RE: Philco 45 squeels - by BrendaAnnD - 09-15-2013, 10:43 PM
RE: Philco 45 squeels - by vinzer - 09-15-2013, 10:58 PM
RE: Philco 45 squeels - by Radioroslyn - 09-15-2013, 11:23 PM
RE: Philco 45 squeels - by marty - 09-15-2013, 11:42 PM
RE: Philco 45 squeels - by BrendaAnnD - 09-16-2013, 03:10 AM
RE: Philco 45 squeels - by marty - 09-16-2013, 09:48 AM
RE: Philco 45 squeels - by Steve Davis - 09-16-2013, 10:19 AM
RE: Philco 45 squeels - by Steve Davis - 09-16-2013, 10:20 AM
RE: Philco 45 squeels - by marty - 09-16-2013, 10:22 AM
RE: Philco 45 squeels - by marty - 09-16-2013, 11:32 AM
RE: Philco 45 squeels - by marty - 09-16-2013, 12:41 PM
RE: Philco 45 squeels - by marty - 09-20-2013, 05:42 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
The speaker table error?
G  10-1/2"       65, 76, 87, 95 Push-Pull 45's 2766 0.7 550 3200 H   10-1/2"    77, 96 Push-Pull...morzh — 09:26 PM
A Marconi model 86
I have a Stromberg, one of the early ones, seems early 30s. This is what I call a back breaker. None of the early Philc...morzh — 08:28 PM
A Marconi model 86
A backbreaker.....PaulPaul Philco322 — 08:12 PM
A Marconi model 86
>>What a behemoth! A Juggernaut.morzh — 07:47 PM
Philco 70 antenna lead
I am not sure I understood about the coils and the mush. I looked an more than one coil in 20, 70, 90, 60, Zeniths and ...morzh — 07:46 PM
A Marconi model 86
:e_biggrin: What a behemoth!  I hope the final result is as much a quality sounding example!  Keep us posted on your pro...GarySP — 07:32 PM
A Marconi model 86
I should add that the double conversion may only be used on the shortwave bands, but I haven't looked at the schematic t...Arran — 07:27 PM
Philco 70 antenna lead
Yes, that wire will not pick up much interference as routed - the RF at that level won't be affected, and if you have st...radio1 — 07:26 PM
Philco model 60
I'm also a member of MARC. Did you attend the Vintage Electronics Expo in Waterford, MI last month? That's where I got...GarySP — 07:22 PM
A Marconi model 86
Dan Double conversion is using two IF converters instead of one. This improves the image response. morzh — 07:15 PM

[-]
Who's Online
There are currently 2368 online users. [Complete List]
» 2 Member(s) | 2366 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration