1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Speaker for 1933 Philco 60L
jerryhawthorne
Phorum Expert
*****
Posts: 1,562
Threads: 56
Joined: Nov 2008
City: Sedona, AZ/Placentia/CA
#14

09-19-2013, 10:00 PM
Tracy, let's just get back to the basics, do you have an ohm meter? If so, radio unplugged and the speaker plug off the back of the chassis, measure the resistance between the plug held in your hand. According the schematic attached as a link, there are 3 lines going to the speaker. Set you meter to perhaps 10K. All three lines should check the field coil and output transformer primary. If the measurements do this (the meter dips down to about 0), they are good. Report back please.
Jerry

http://www.nostalgiaair.org/PagesByModel...013793.pdf
A friend in need is a pest!  Bill Slee ca 1970.
Find
« Next Oldest | Next Newest »


Messages In This Thread
Speaker for 1933 Philco 60L - by Tracy1928 - 09-03-2013, 02:44 PM
RE: Speaker for 1928 Philco 91L - by Ron Ramirez - 09-03-2013, 03:41 PM
RE: Speaker for 1928 Philco 91L - by Tracy1928 - 09-03-2013, 04:42 PM
RE: Speaker for 1928 Philco 91L - by Tracy1928 - 09-03-2013, 04:47 PM
RE: Speaker for 1928 Philco 91L - by Ron Ramirez - 09-03-2013, 08:43 PM
RE: Speaker for 1928 Philco 91L - by Tracy1928 - 09-04-2013, 03:07 PM
RE: Speaker for 1928 Philco 91L - by Tracy1928 - 09-18-2013, 03:42 PM
RE: Speaker for 1933 Philco 60L - by Radioroslyn - 09-18-2013, 04:03 PM
RE: Speaker for 1928 Philco 91L - by Tracy1928 - 09-18-2013, 04:36 PM
RE: Speaker for 1928 Philco 91L - by Radioroslyn - 09-18-2013, 08:11 PM
RE: Speaker for 1933 Philco 60L - by Tracy1928 - 09-19-2013, 11:18 AM
RE: Speaker for 1933 Philco 60L - by Radioroslyn - 09-19-2013, 09:11 PM
RE: Speaker for 1933 Philco 60L - by jerryhawthorne - 09-19-2013, 10:00 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
Outstanding work indeed. I wish I could come up with solutions like this.slford310 — 11:16 PM
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM

[-]
Who's Online
There are currently 3966 online users. [Complete List]
» 1 Member(s) | 3965 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios