1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 112 Lowboy restoration (caution, lots of images)
PhilcoPhil
Junior Member
**
Posts: 33
Threads: 8
Joined: Nov 2007
#2

03-27-2008, 05:49 PM
Great pictures!!! I can't answer your question about corrosion. And, it's funny, I ALWAYS have that urge to plug it in when I shouldn't. Good Luck and so far so good...cabinet looks great too. Thanks for sharing.
Find
« Next Oldest | Next Newest »


Messages In This Thread
[No subject] - by PhilcoPhil - 03-27-2008, 05:49 PM
[No subject] - by Ron Ramirez - 03-27-2008, 05:51 PM
[No subject] - by gary rabbitt - 04-06-2008, 01:32 PM
[No subject] - by BDM - 04-06-2008, 06:15 PM
[No subject] - by audin - 04-08-2008, 02:38 PM
[No subject] - by audin - 04-08-2008, 02:41 PM
[No subject] - by audin - 04-08-2008, 02:59 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently 4742 online users. [Complete List]
» 1 Member(s) | 4741 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration