Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

41-95 schematic
#9

Sorry, Brenda, for not getting back on the model. It is
the table model unit. I'm kind of surprised to see a
push pull output on this battery set. Kind of wondering
about the B+ not going to the plates on the output.
Jim


Messages In This Thread
41-95 schematic - by brownie45 - 09-25-2013, 10:30 AM
RE: 41-99 schematic - by marty - 09-25-2013, 11:00 AM
RE: 41-99 schematic - by Carl Travis - 09-25-2013, 11:04 AM
RE: 41-99 schematic - by marty - 09-25-2013, 11:07 AM
RE: 41-99 schematic - by brownie45 - 09-25-2013, 01:32 PM
RE: 41-99 schematic - by BrendaAnnD - 09-25-2013, 03:50 PM
RE: 41-99 schematic - by klondike98 - 09-25-2013, 03:59 PM
RE: 41-99 schematic - by brownie45 - 09-25-2013, 07:12 PM
RE: 41-95 schematic - by brownie45 - 09-26-2013, 01:30 PM
RE: 41-95 schematic - by brownie45 - 11-23-2013, 11:04 AM
RE: 41-95 schematic - by Raleigh - 11-29-2013, 04:52 PM
RE: 41-95 schematic - by brownie45 - 11-30-2013, 07:39 AM
RE: 41-95 schematic - by brownie45 - 12-11-2013, 09:27 PM
RE: 41-95 schematic - by Radioroslyn - 12-11-2013, 11:55 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 3329 online users. [Complete List]
» 1 Member(s) | 3328 Guest(s)
Avatar

>