Philco 640 Cabinet Refinishing Chronicles
Posts: 761
Threads: 56
Joined: Jul 2013
City: Kentucky
Be sure to cut that pore-o-pac with mineral spirits before you use it. Make it like thick paint. And once more, applying clear before toner is just a waste of clear and will make it easier to get runs in the toner.
If this is your first time, I highly recommend you get some Mohawk Blender flow out. It is like spray thinner... if you get a run, or a hair floats into your finish... you use the blender flow out to add drying time and make the lacquer flow over the mistake... or in the case of a small run, flow out into the surrounding lacquer. It will save you from stripping and starting over. It is insurance in a can.
The artist formerly known as Puhpow! 8)
(This post was last modified: 10-01-2013, 05:02 PM by Jamie.)
Messages In This Thread
RE: Philco 640 Cabinet Refinishing Chronicles - by Jamie - 10-01-2013, 04:58 PM
Users browsing this thread: 2 Guest(s)
|
Recent Posts
|
PT-6 antenna connections
|
Hi Bridcarl
+1 on the others. Pin 6 of the 7C6 is the AVC Diode so it is appropriate that that pin 4 of the coil con...MrFixr55 — 07:30 AM |
462ron
|
Joseph, this is beyond awesome. A lot of thought and engineering went into this and you hit a home run! Now I must save ...462ron — 07:27 AM |
Cannot Adjust an IF Transformer’s cores
|
Outstanding work indeed. I wish I could come up with solutions like this.slford310 — 11:16 PM |
Cannot Adjust an IF Transformer’s cores
|
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM |
PT-6 antenna connections
|
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM |
Cannot Adjust an IF Transformer’s cores
|
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM |
PT-6 antenna connections
|
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4.
Yes, pin 6 of the 7C6 is...RodB — 07:34 PM |
bridkarl
|
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM |
Cannot Adjust an IF Transformer’s cores
|
Joseph, now you are an engineer!!RodB — 06:37 PM |
PT-6 antenna connections
|
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM |
Who's Online
|
There are currently 3628 online users. [Complete List] » 3 Member(s) | 3625 Guest(s)
|
|
|
![>](https://philcoradio.com/phorum/images/bootbb/asb/right_arrow.png)
|