Model 86 Help

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Model 86 Help

dfields69
Member

Posts: 54
Threads: 10
Joined: Sep 2013
City: Roanoke, Va.

10-01-2013, 06:59 PM

THANK YOU THANK YOU THANK YOU! Every bit of this information has been extremely helpful! The power transformer on this set has two voltage setting as well as 3 crumbly rubber wires leading from the switch to the transformer. setting is for 95 - 110 V or straight 110 V, it appears. Which setting is the best and I was going to shrink tube the wires to prevent having to break the transformer down. Any recommendations there as well?

Find

« Next Oldest | Next Newest »

Messages In This Thread

Model 86 Help - by dfields69 - 09-28-2013, 03:56 PM

RE: Model 86 Help - by Radioroslyn - 09-28-2013, 06:48 PM

RE: Model 86 Help - by TA Forbes - 09-30-2013, 11:19 AM

RE: Model 86 Help - by Radioroslyn - 09-30-2013, 01:31 PM

RE: Model 86 Help - by dfields69 - 10-01-2013, 06:55 PM

RE: Model 86 Help - by dfields69 - 10-01-2013, 06:59 PM

RE: Model 86 Help - by dfields69 - 10-27-2013, 04:56 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone, As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

Who's Online

There are currently 5498 online users. [Complete List]
» 1 Member(s) | 5497 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me