1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Finally found one (locally)
TA Forbes
Deviate Emeritus
*****
Posts: 2,353
Threads: 92
Joined: May 2010
City: Clayton, NC
#16

10-08-2013, 02:57 PM
I have an H-13 speaker that should work with your set. Output xfrmr is bad but field coil/voice coil are good. Cone intact, has couple of minor tears, easy fix.

You will have to drill out the rivets and remove the old output xfrmr and replace it with yours. CAREFUL... cone is directly under rivets.

PM me with your address. We can work out the details later.
Find
« Next Oldest | Next Newest »


Messages In This Thread
Finally found one (locally) - by TimC - 07-23-2013, 05:40 PM
RE: Finally found one (locally) - by Ron Ramirez - 07-23-2013, 08:00 PM
RE: Finally found one (locally) - by PhilcoJohn - 08-03-2013, 09:47 AM
RE: Finally found one (locally) - by TimC - 08-04-2013, 06:45 PM
RE: Finally found one (locally) - by TimC - 08-05-2013, 06:37 PM
RE: Finally found one (locally) - by PhilcoJohn - 10-02-2013, 07:34 AM
RE: Finally found one (locally) - by TA Forbes - 10-06-2013, 02:24 PM
RE: Finally found one (locally) - by Jamie - 10-06-2013, 04:18 PM
RE: Finally found one (locally) - by TimC - 10-06-2013, 08:10 PM
RE: Finally found one (locally) - by TA Forbes - 10-07-2013, 04:04 PM
RE: Finally found one (locally) - by TimC - 10-08-2013, 07:57 AM
RE: Finally found one (locally) - by TA Forbes - 10-08-2013, 02:57 PM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM

[-]
Who's Online
There are currently 3910 online users. [Complete List]
» 3 Member(s) | 3907 Guest(s)
AvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios