|
46-350 Electrolytic Cap Explosion?
04-02-2008, 11:38 PM
justlrnin, hi. moving the switch to the plate side = move switch from ground leg to high side of line and run neutral line cord wire directly to chassis. This has to be done with a replacement "polarized" plug (wide spade/blade neutral). If you don't replace line plug chassis will still be hot sometimes and that sometimes will be when you forget the one hand method and get a belt. PL
« Next Oldest | Next Newest »
Messages In This Thread
[No subject] - by justlrnin - 02-27-2008, 08:32 PM
[No subject] - by Ron Ramirez - 02-27-2008, 10:44 PM
[No subject] - by Texasrocker - 02-28-2008, 12:32 AM
[No subject] - by Chuck Schwark - 02-28-2008, 08:58 AM
[No subject] - by justlrnin - 02-28-2008, 12:07 PM
[No subject] - by Chuck Schwark - 02-28-2008, 12:15 PM
[No subject] - by justlrnin - 02-28-2008, 02:33 PM
[No subject] - by Guest - 02-28-2008, 05:32 PM
[No subject] - by Texasrocker - 02-29-2008, 02:34 AM
[No subject] - by FStephenMasek - 04-01-2008, 10:33 AM
[No subject] - by justlrnin - 04-01-2008, 11:35 AM
[No subject] - by Alan Douglas - 04-01-2008, 07:19 PM
[No subject] - by FStephenMasek - 04-02-2008, 09:42 AM
[No subject] - by planigan - 04-02-2008, 11:38 PM
[No subject] - by exray - 04-03-2008, 06:37 AM
[No subject] - by justlrnin - 04-03-2008, 11:15 AM
[No subject] - by planigan - 04-03-2008, 10:46 PM
[No subject] - by planigan - 04-04-2008, 06:54 PM
Users browsing this thread: 1 Guest(s) |
