Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Pilot lamp blows out
#5

Do you have the correct pilot lamp installed?
Keep in mind that with most sets using that tube, the plate current flows through the dial lamp (and hopefully the resistor in parallel with the lamp) SO if the radio is pulling too much B+ the pilot lamp will blow.

Tube datasheet: http://tubedata.milbert.com/sheets/049/3/35Y4.pdf

It's about the same thing as a 35Z5, so this page from Chucks site might be of interest as well:

http://www.philcorepairbench.com/tips/svctip40.htm

John
Las Vegas, NV USA


Messages In This Thread
Pilot lamp blows out - by Buzz - 10-16-2013, 07:27 PM
RE: Pilot lamp blows out - by Radioroslyn - 10-16-2013, 08:06 PM
RE: Pilot lamp blows out - by BrendaAnnD - 10-16-2013, 08:25 PM
RE: Pilot lamp blows out - by Buzz - 10-16-2013, 09:04 PM
RE: Pilot lamp blows out - by LASJayhawk - 10-16-2013, 10:47 PM
RE: Pilot lamp blows out - by Buzz - 10-17-2013, 10:37 AM
RE: Pilot lamp blows out - by LASJayhawk - 10-17-2013, 01:14 PM
RE: Pilot lamp blows out - by Buzz - 10-21-2013, 07:28 PM
RE: Pilot lamp blows out - by Randy H. - 11-12-2013, 07:36 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
1949 Motorola 5A9M
Haven't thought of Burgess batteres in a while  https://www.radionostalgia.ca/lib/Images/battery/us/burgess1D.jpgi ...Vlad95 — 03:50 PM
Philco Model 16 wiring question
Measure the voltages first, just in case.morzh — 02:19 PM
1949 Motorola 5A9M
Haven't thought of Burgess batteries in a while Mr. Fixer. Boston Edison always used Burgess in their Bright Star yellow...Paul Philco322 — 02:17 PM
1949 Motorola 5A9M
Thanks Sam. I'll let you know. I can probably scare some up from the local radio club.klondike98 — 02:07 PM
Philco 89 Code 123 Osc Coil
Hello,  I thought I would post my findings on my bad oscillator tickler coil. There were 27 turns on the outer coil b...dconant — 12:38 PM
Philco Model 16 wiring question
Thanks Morzh. So it appears I did wire it incorrectly and I have to switch the wires between pins 2 and 4.bobclausen — 09:24 AM
Philco 46-1209 strange behavior
No, it's not a problem, just during certain condition it could show up. Yes, an internal tube short could do that too. ...morzh — 09:13 AM
HiFi (Chifi) tube amp build - but my own design.
You sound guys are never satisfied. :crazy: :clap:RodB — 09:10 AM
HiFi (Chifi) tube amp build - but my own design.
I got some new ceramic octal tube sockets installed and also tried some different coupling caps.  The results:  The go...TV MAN — 08:42 AM
Philco 46-1209 strange behavior
I pulled the tube out and it's shorted from pin 1 to pin 2. I suppose that's the problem...sq65 — 08:12 AM

[-]
Who's Online
There are currently 1187 online users. [Complete List]
» 1 Member(s) | 1186 Guest(s)
Avatar

>