Pilot lamp blows out

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Pilot lamp blows out

Buzz
Senior Member

Posts: 360
Threads: 60
Joined: Jan 2013
City: Portland, Oregon

10-17-2013, 10:37 AM

Hi:
Using a #47 bulb per schematic.
My schematic has no resistor in parallel.
Do you think I should add one?
Phil's tips say to use a 300 ohm 5 watt resistor.
thanx,
Buzz

Find

« Next Oldest | Next Newest »

Messages In This Thread

Pilot lamp blows out - by Buzz - 10-16-2013, 07:27 PM

RE: Pilot lamp blows out - by Radioroslyn - 10-16-2013, 08:06 PM

RE: Pilot lamp blows out - by BrendaAnnD - 10-16-2013, 08:25 PM

RE: Pilot lamp blows out - by Buzz - 10-16-2013, 09:04 PM

RE: Pilot lamp blows out - by LASJayhawk - 10-16-2013, 10:47 PM

RE: Pilot lamp blows out - by Buzz - 10-17-2013, 10:37 AM

RE: Pilot lamp blows out - by LASJayhawk - 10-17-2013, 01:14 PM

RE: Pilot lamp blows out - by Buzz - 10-21-2013, 07:28 PM

RE: Pilot lamp blows out - by Randy H. - 11-12-2013, 07:36 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone, As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

Who's Online

There are currently 4914 online users. [Complete List]
» 2 Member(s) | 4912 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me