Schematic/Alignment Data Request

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Schematic/Alignment Data Request

N6MKC
Junior Member

Posts: 11
Threads: 6
Joined: Feb 2013
City: Camino, CA

10-25-2013, 12:38 PM

Thanks for the tips.

I normally pull schematics from a Rider's Perpetual, scan it high-res, and print it spanned out across 6 to 9 pieces of paper which I then tape together poster-sized and hang on the wall. The bigger and clearer the schematic, the easier the radio is to work on.

Find

« Next Oldest | Next Newest »

Messages In This Thread

Schematic/Alignment Data Request - by N6MKC - 10-25-2013, 11:12 AM

RE: Schematic/Alignment Data Request - by TA Forbes - 10-25-2013, 11:59 AM

RE: Schematic/Alignment Data Request - by N6MKC - 10-25-2013, 12:38 PM

RE: Schematic/Alignment Data Request - by fordtech - 10-26-2013, 05:39 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone, As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me