Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Zenith 5R312 voltages
#9

If it were mine I would go the bucking transformer route, connect a 6.3 volt or higher voltage transformer in series with the primary. The working line voltage was normally 117 volts on a 60 cycle set, unless it was a 25 cycle set then it was 115 volts at 25 cycles.
Regards
Arran


Messages In This Thread
Zenith 5R312 voltages - by Buzz - 11-01-2013, 09:30 PM
RE: Zenith 5R312 voltages - by morzh - 11-01-2013, 10:38 PM
RE: Zenith 5R312 voltages - by Buzz - 11-01-2013, 10:42 PM
RE: Zenith 5R312 voltages - by BrendaAnnD - 11-01-2013, 10:48 PM
RE: Zenith 5R312 voltages - by Arran - 11-01-2013, 11:06 PM
RE: Zenith 5R312 voltages - by Mondial - 11-02-2013, 12:06 AM
RE: Zenith 5R312 voltages - by Buzz - 11-03-2013, 06:28 PM
RE: Zenith 5R312 voltages - by morzh - 11-03-2013, 10:44 PM
RE: Zenith 5R312 voltages - by Arran - 11-04-2013, 03:10 AM
RE: Zenith 5R312 voltages - by Buzz - 11-04-2013, 12:36 PM
RE: Zenith 5R312 voltages - by BrendaAnnD - 11-04-2013, 03:43 PM
RE: Zenith 5R312 voltages - by morzh - 11-04-2013, 08:52 PM
RE: Zenith 5R312 voltages - by Buzz - 11-04-2013, 09:58 PM
RE: Zenith 5R312 voltages - by Arran - 11-04-2013, 10:14 PM
RE: Zenith 5R312 voltages - by morzh - 11-04-2013, 10:22 PM
RE: Zenith 5R312 voltages - by Buzz - 11-08-2013, 10:43 PM
RE: Zenith 5R312 voltages - by Arran - 11-09-2013, 03:09 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 45L Initial Check Up
Hello, I am in the process of checking out a Philco 45L. My question is does this model suffer from the Philco coil r...dconant — 06:11 PM
Philco 42-345 Restoration/Repair
The 2 towns you mentioned "Frustrated" and "Give Up" are places we have all been. Relax, take 5, thi...Paul Philco322 — 03:23 PM
Philco 89 Code 123 Osc Coil
Thanks for posting that information!klondike98 — 03:14 PM
Philco 42-345 Restoration/Repair
From what I see is the blue cap was added by someone after the radio was sold presumably to replace cap 40A. I can't tel...RodB — 03:12 PM
Philco 42-345 Restoration/Repair
Correction My original picture shows #40 cap, blue cap and #42 resistor connected.osanders0311 — 02:23 PM
Philco 42-345 Restoration/Repair
Well guys I am stuck, frustrated and about ready to give up. For starters all I'm getting from the speaker is a humming ...osanders0311 — 02:17 PM
[split] New member...
Thanks.  I'll try that.HowardWoodard — 01:13 PM
[split] New member...
You may have to start further back with your signal injection at the IF signal grid, then tune the second IF transformer...RodB — 10:28 AM
[split] New member...
Well, with the replacement tuning assembly, I have finally put the unit back together and aligned the dial.  The first s...HowardWoodard — 01:01 AM
Philco Model 16 wiring question
Well, finding a short is easy. Like I said, disconnect the transformer's secondary windings and see if it persists. If...morzh — 09:48 PM

[-]
Who's Online
There are currently 943 online users. [Complete List]
» 3 Member(s) | 940 Guest(s)
AvatarAvatarAvatar

>