1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
BV-613 various questions
BrendaAnnD
Phorum Expert
*****
Posts: 1,108
Threads: 89
Joined: Jun 2011
City: Tacoma State, Province, Country: Washington
#4

11-08-2013, 07:19 PM
Sounds like those 4522D's were originally 1.0 uf. Use 630V replacements.
Find
« Next Oldest | Next Newest »


Messages In This Thread
BV-613 various questions - by 64EK26 - 11-08-2013, 01:49 PM
RE: BV-613 various questions - by BrendaAnnD - 11-08-2013, 03:33 PM
RE: BV-613 various questions - by 64EK26 - 11-08-2013, 06:27 PM
RE: BV-613 various questions - by BrendaAnnD - 11-08-2013, 07:19 PM
RE: BV-611 restoration - by 64EK26 - 12-19-2013, 03:38 PM
RE: BV-613 various questions - by codefox1 - 12-19-2013, 06:09 PM
RE: BV-613 various questions - by Mondial - 12-19-2013, 10:36 PM
RE: BV-613 various questions - by 64EK26 - 12-20-2013, 01:50 PM
RE: BV-613 various questions - by morzh - 12-20-2013, 02:41 PM
RE: BV-613 various questions - by 64EK26 - 12-20-2013, 04:04 PM
RE: BV-613 various questions - by Mondial - 12-20-2013, 06:03 PM
RE: BV-613 various questions - by 64EK26 - 12-21-2013, 04:15 PM
RE: BV-613 various questions - by Mondial - 12-21-2013, 08:17 PM
RE: BV-613 various questions - by klondike98 - 08-19-2017, 10:45 AM
RE: BV-613 various questions - by Radioroslyn - 08-19-2017, 12:03 PM
RE: BV-613 various questions - by Cesardeluxe - 10-14-2018, 04:03 PM
RE: BV-613 various questions - by Cesardeluxe - 11-05-2018, 07:26 AM
RE: BV-613 various questions - by klondike98 - 11-05-2018, 08:58 AM
RE: BV-613 various questions - by Radioroslyn - 11-05-2018, 12:42 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration