|
Rusty Tuning Condenser
|
| Give the tuner a good wash in Dawn and hot water. Then set tuner in a plastic container and cover with vinegar let soak ...David — 12:53 PM |
|
Rusty Tuning Condenser
|
| If you have rust between the vanes, I wonder how you get the NJ in between, and how you then wipe it off.morzh — 12:02 PM |
|
Philco 60 Squealing
|
| If the noise is still there, the OPT might just be OK. Or so we hope.morzh — 12:01 PM |
|
Philco 60 Squealing
|
| You would probably be replacing the OPT.RodB — 10:54 AM |
|
Philco 60 Squealing
|
| I have been playing the radio for a while now and doing well. Turned it on today and all I got was a whole lot of noise....dconant — 09:39 AM |
|
Rusty Tuning Condenser
|
| Thanks guys. I think I'll give the Naval Jelly a try since I can better control where it goes.dconant — 09:23 AM |
|
Philco Model 80 Transformer resistance
|
| Just forget this number, it is useless anyway.
Simply proceed with your project.morzh — 10:08 PM |
|
Philco Model 80 Transformer resistance
|
| My $0.02 is that it is a misprint. I tried to look up the value for the similar 84 and 37-84, and ther is no resistance...MrFixr55 — 09:51 PM |
|
Philco Model 80 Transformer resistance
|
| Thanks for the quick reply!
Hmm...well that's good, so what am I seeing that's 1042 ohms on the schematic for the pow...Mike L — 08:46 PM |
|
Philco Model 80 Transformer resistance
|
| The DC resistance of the primary is 8 to 9 Ohm.morzh — 07:54 PM |
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
