Removing Rodent Odor

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Removing Rodent Odor

Joeztech
Senior Member

Posts: 348
Threads: 48
Joined: Oct 2013
City: Tioga, Texas, USA

11-18-2013, 05:38 PM

[attachment=2991I finished doing a preliminary cleaning of the cabinet and chassis. I have some pictures I will try to post. The damage I saw on the left end of the base turned out to be due to termites! Fortunately it is confined to the lowest board glued to the base trim. It should be easy to replace.

Joe

Attached Files Image(s)

(This post was last modified: 11-18-2013, 11:57 PM by Joeztech.)

Find

« Next Oldest | Next Newest »

Messages In This Thread

Removing Rodent Odor - by Joeztech - 11-17-2013, 08:42 AM

RE: Removing Rodent Odor - by Phlogiston - 11-17-2013, 12:45 PM

RE: Removing Rodent Odor - by Joeztech - 11-17-2013, 09:28 PM

RE: Removing Rodent Odor - by Joeztech - 11-18-2013, 05:38 PM

RE: Removing Rodent Odor - by Phlogiston - 11-18-2013, 07:44 PM

RE: Removing Rodent Odor - by Joeztech - 11-18-2013, 08:20 PM

RE: Removing Rodent Odor - by Arran - 11-19-2013, 03:43 AM

RE: Removing Rodent Odor - by Joeztech - 11-19-2013, 07:52 AM

RE: Removing Rodent Odor - by klondike98 - 11-19-2013, 10:05 AM

RE: Removing Rodent Odor - by Joeztech - 11-19-2013, 06:28 PM

RE: Removing Rodent Odor - by Steve Davis - 11-19-2013, 06:51 PM

RE: Removing Rodent Odor - by Joeztech - 11-19-2013, 08:47 PM

RE: Removing Rodent Odor - by klondike98 - 11-19-2013, 10:29 PM

RE: Removing Rodent Odor - by tom.seeger - 11-19-2013, 10:31 PM

RE: Removing Rodent Odor - by Joeztech - 11-20-2013, 08:32 AM

RE: Removing Rodent Odor - by Joeztech - 11-20-2013, 07:00 PM

RE: Removing Rodent Odor - by Joeztech - 11-23-2013, 03:05 PM

RE: Removing Rodent Odor - by Joeztech - 11-23-2013, 03:25 PM

RE: Removing Rodent Odor - by Joeztech - 11-28-2013, 06:00 PM

RE: Removing Rodent Odor - by Joeztech - 11-29-2013, 05:59 PM

RE: Removing Rodent Odor - by Ron Ramirez - 11-29-2013, 06:01 PM

RE: Removing Rodent Odor - by Ron Ramirez - 11-29-2013, 06:03 PM

RE: Removing Rodent Odor - by Joeztech - 11-30-2013, 07:51 AM

RE: Removing Rodent Odor - by Ron Ramirez - 11-30-2013, 08:45 AM

RE: Removing Rodent Odor - by Joeztech - 12-01-2013, 06:30 PM

View a Printable Version

Users browsing this thread: 3 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me