Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

42-321 questions
#4

I followed Morzh's advise and measured the resistance. 500 mohm with the volume closed and 3 ohms (or so) with the volume full open. I will verify when I my new schematic arrives. The copy I got from Nostalgia air was not that clear.


Messages In This Thread
42-321 questions - by ke5yum - 11-14-2013, 09:20 AM
RE: 42-321 questions - by klondike98 - 11-14-2013, 08:18 PM
RE: 42-321 questions - by morzh - 11-15-2013, 12:00 AM
RE: 42-321 questions - by ke5yum - 11-19-2013, 09:20 AM
RE: 42-321 questions - by morzh - 11-19-2013, 02:39 PM
RE: 42-321 questions - by ke5yum - 11-20-2013, 08:56 AM
RE: 42-321 questions - by codefox1 - 11-20-2013, 04:35 PM
RE: 42-321 questions - by ke5yum - 11-26-2013, 08:51 AM
RE: 42-321 questions - by vinzer - 11-26-2013, 12:44 PM
RE: 42-321 questions - by ke5yum - 12-11-2013, 09:06 AM
RE: 42-321 questions - by klondike98 - 12-11-2013, 10:43 AM
RE: 42-321 questions - by ke5yum - 12-11-2013, 11:20 AM



Users browsing this thread: 5 Guest(s)
[-]
Recent Posts
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM
Philco 42-1008 conversion kit
I read about a kit to convert the variable speed changer in the Philco 42-1008 into a single speed unit.  That would rem...alangard — 09:30 PM

[-]
Who's Online
There are currently 6088 online users. [Complete List]
» 1 Member(s) | 6087 Guest(s)
Avatar

>