Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Another Philco Radio Question
#6

That's what I haqve always heard about the Philco coils - the nitric acid in the celluloid damages the coils. It's usually the primaries (outer windings) that suffer the damage, but in advanced cases the inner (secondary) windings can also get the "greenies" as well.

Sulphur in the wax makes sense also. And a combination of these plus moisture equals trouble at some point for the coils.

As Chuck said, these radios were not intended to last 3/4 of a century or more. That many have is a testament to how well products were once made. To say more would mean going political, so let's leave it at that.

--
Ron Ramirez
Ferdinand IN


Messages In This Thread
Another Philco Radio Question - by PhilcoJohn - 11-20-2013, 06:58 PM
RE: Another Philco Radio Question - by PhilcoJohn - 11-21-2013, 06:55 PM
RE: Another Philco Radio Question - by Arran - 11-23-2013, 04:36 AM
RE: Another Philco Radio Question - by Ron Ramirez - 11-24-2013, 09:02 AM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Not sure if anyone has tried this but there are 6.3 volt miniature lamps in bayonet and screw-in base options available ...GarySP — 11:31 AM
Shadow Meter Bulb
Any 6.3 volt pilot light will work. I would use the brightest one I could find in my workroom. Be sure the dial is clean...RodB — 10:45 AM
HiFi (Chifi) tube amp build - but my own design.
Tim, nice write up and thanks for sharing !! Sincerely Richardradiorich — 02:47 AM
HiFi (Chifi) tube amp build - but my own design.
Well, this was a real "Hum-Dinger" :lol: ! This will be kinda long, but hopefully it will help others having t...TV MAN — 01:55 AM
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM

[-]
Who's Online
There are currently no members online.

>