Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 40-201 Speaker
#15

It was not a factory option, it was done later. Some techs were neater than others when it came to adding those jacks to chassis.

--
Ron Ramirez
Ferdinand IN


Messages In This Thread
Philco 40-201 Speaker - by Joeztech - 11-17-2013, 10:17 AM
RE: Philco 40-201 Speaker - by Radioroslyn - 11-18-2013, 09:06 AM
RE: Philco 40-201 Speaker - by Joeztech - 11-18-2013, 03:13 PM
RE: Philco 40-201 Speaker - by Joeztech - 11-18-2013, 06:18 PM
RE: Philco 40-201 Speaker - by BrendaAnnD - 11-18-2013, 08:11 PM
RE: Philco 40-201 Speaker - by Joeztech - 11-18-2013, 08:31 PM
RE: Philco 40-201 Speaker - by Joeztech - 11-19-2013, 06:49 PM
RE: Philco 40-201 Speaker - by Joeztech - 11-20-2013, 07:54 PM
RE: Philco 40-201 Speaker - by Ron Ramirez - 11-20-2013, 08:45 PM
RE: Philco 40-201 Speaker - by Joeztech - 11-20-2013, 08:52 PM
RE: Philco 40-201 Speaker - by Ron Ramirez - 11-20-2013, 09:04 PM
RE: Philco 40-201 Speaker - by Joeztech - 11-21-2013, 07:15 PM
RE: Philco 40-201 Speaker - by Joeztech - 11-21-2013, 07:54 PM
RE: Philco 40-201 Speaker - by Joeztech - 11-23-2013, 02:35 PM
RE: Philco 40-201 Speaker - by Ron Ramirez - 11-26-2013, 06:47 AM
RE: Philco 40-201 Speaker - by Joeztech - 11-26-2013, 07:52 AM
RE: Philco 40-201 Speaker - by Steve D - 11-26-2013, 09:12 AM
RE: Philco 40-201 Speaker - by Mondial - 11-26-2013, 06:49 PM
RE: Philco 40-201 Speaker - by Joeztech - 11-26-2013, 07:20 PM
RE: Philco 40-201 Speaker - by Mondial - 11-26-2013, 08:57 PM
RE: Philco 40-201 Speaker - by Joeztech - 11-26-2013, 09:01 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently no members online.

>