Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Type 82 rectifier
#3

That's the ten tube version of one of their deep chassis series sets from 1931-32. While it may have been made by RCA at the time, thanks to the Supreme Court anti trust judgement in 1930, most of the engineering was probably done over at G.E and or Westinghouse.
From what I heard these sets are real thumpers once you get them playing right. I've only worked on the smaller 8 tube Canadian G.E/RCA/Westinghouse chassis from that era and even those are good performers.
Regards
Arran


Messages In This Thread
Type 82 rectifier - by BrendaAnnD - 12-07-2013, 10:45 PM
RE: Type 82 rectifier - by Mondial - 12-07-2013, 11:11 PM
RE: Type 82 rectifier - by Arran - 12-08-2013, 12:03 AM
RE: Type 82 rectifier - by BrendaAnnD - 12-08-2013, 01:12 AM
RE: Type 82 rectifier - by Phlogiston - 12-08-2013, 02:40 AM
RE: Type 82 rectifier - by BrendaAnnD - 12-08-2013, 04:33 AM
RE: Type 82 rectifier - by Phlogiston - 12-08-2013, 11:12 AM
RE: Type 82 rectifier - by codefox1 - 12-08-2013, 12:54 PM
RE: Type 82 rectifier - by BrendaAnnD - 12-08-2013, 02:38 PM
RE: Type 82 rectifier - by jerryhawthorne - 12-08-2013, 06:06 PM
RE: Type 82 rectifier - by Arran - 12-09-2013, 12:50 AM
RE: Type 82 rectifier - by codefox1 - 12-09-2013, 01:49 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM
40-150 General questions
Good thing you're a good electrician ... the pictures show a lot of rewiring in your future! Take care and BE HEALTHY!...GarySP — 11:52 AM

[-]
Who's Online
There are currently 4129 online users. [Complete List]
» 1 Member(s) | 4128 Guest(s)
Avatar

>