1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 40-190 resistor
murf
Senior Member
****
Posts: 669
Threads: 145
Joined: Jun 2011
City: Elko,MN.
#11

12-08-2013, 05:12 PM
There is a 41-250 chassis on fleabay which would fit as well.
Not sure about the speaker though.
This is from a table radio instead of a console.
I think the 41-350 uses an 8 inch speaker.
(This post was last modified: 12-08-2013, 09:16 PM by murf.)
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
Philco 40-190 resistor - by murf - 12-07-2013, 03:49 PM
RE: Philco 40-190 resistor - by Warren - 12-07-2013, 11:34 PM
RE: Philco 40-190 resistor - by murf - 12-08-2013, 12:28 AM
RE: Philco 40-190 resistor - by DeckApe - 12-08-2013, 10:08 AM
RE: Philco 40-190 resistor - by DeckApe - 12-08-2013, 11:47 AM
RE: Philco 40-190 resistor - by Mondial - 12-08-2013, 12:01 PM
RE: Philco 40-190 resistor - by murf - 12-08-2013, 01:03 PM
RE: Philco 40-190 resistor - by DeckApe - 12-08-2013, 04:13 PM
RE: Philco 40-190 resistor - by murf - 12-08-2013, 04:32 PM
RE: Philco 40-190 resistor - by DeckApe - 12-08-2013, 04:52 PM
RE: Philco 40-190 resistor - by murf - 12-08-2013, 05:12 PM
RE: Philco 40-190 resistor - by 37silverstreak - 12-08-2013, 06:52 PM
RE: Philco 40-190 resistor - by murf - 12-08-2013, 09:19 PM
RE: Philco 40-190 resistor - by Mondial - 12-08-2013, 09:33 PM
RE: Philco 40-190 resistor - by BrendaAnnD - 12-08-2013, 11:02 PM
RE: Philco 40-190 resistor - by BrendaAnnD - 12-08-2013, 11:03 PM
RE: Philco 40-190 resistor - by murf - 12-09-2013, 06:38 PM
RE: Philco 40-190 resistor - by 37silverstreak - 12-09-2013, 08:24 PM
RE: Philco 40-190 resistor - by DeckApe - 12-09-2013, 09:13 PM
RE: Philco 40-190 resistor - by murf - 12-09-2013, 09:38 PM
RE: Philco 40-190 resistor - by 37silverstreak - 12-09-2013, 11:26 PM
RE: Philco 40-190 resistor - by murf - 12-17-2013, 11:35 PM
RE: Philco 40-190 resistor - by Mondial - 12-18-2013, 12:03 AM
RE: Philco 40-190 resistor - by murf - 12-18-2013, 07:55 AM
RE: Philco 40-190 resistor - by murf - 12-21-2013, 05:48 PM
RE: Philco 40-190 resistor - by morzh - 12-21-2013, 07:58 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
An attempt to remove the Field Coil from a G speaker
Mike; I've only run into a speaker with an open filed coil twice, and they were on newer speakers from the 1940s. One ...Arran — 12:48 AM
An attempt to remove the Field Coil from a G speaker
Arran Yes, this is my plan for now and what do I got to lose, this is not even the speaker from this radio, but one o...morzh — 10:44 PM
An attempt to remove the Field Coil from a G speaker
Mike;  I would unwrap the field coil, and see if maybe there a break near one of the ends, like where the coil wire att...Arran — 10:23 PM
An attempt to remove the Field Coil from a G speaker
...and this is what I did. I fed a little LT into the screwholes with a small brush, and a little on the rim next to the...morzh — 09:52 PM
Philco 40-120C Restoration
I combined the two 40-120C threads together as we like to keep the discussion of the same radio together. It helps with...klondike98 — 09:36 PM
Philco 40-120C Weak, Distorted Ouput
Just checked were I buy tubes price is four dollars. So living in Florid we have a local source for tubes. David    David — 09:14 PM
Philco 40-120C Weak, Distorted Ouput
The higher voltage may be due to higher mains voltage. My mains run 120-125AC when the set was new mains would be 110-11...David — 09:09 PM
Philco 40-120C Weak, Distorted Ouput
Thank you for your reply. I pulled a speaker from a Philco 41-221 and received the same result. I used a signal tracer t...bluecap — 08:45 PM
Philco 40-120C Weak, Distorted Ouput
Have you tried a different speaker? How did you trace the distortion? How do you know it is weak? What is the reference?...morzh — 08:33 PM
Philco 46-480 Electronic Restoration
Amen to that! Every time I think I’ve captured them all, I realize that there’s another error. My goal is to finish with...jrblasde — 07:00 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration