Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Bang & Olufsen Master de Luxe 39 S
#3

Hi Jan,
Nice to see you here and that's a wonderful set you have. I'm the proud owner of a Master 38K. Interesting radio. Although it has been stored away for a few years I recently pulled it out again to clean and check it. Still working fine.

It uses a 104kc IF frequency and depends on a lot of front-end selectivity to prevent images. The RF coil deck looks very similar to yours. Its a good performer.

-Bill

   


Messages In This Thread
Bang & Olufsen Master de Luxe 39 S - by jcr1972 - 12-08-2013, 07:13 AM
RE: Bang & Olufsen Master de Luxe 39 S - by jontz - 12-08-2013, 09:14 AM
RE: Bang & Olufsen Master de Luxe 39 S - by exray - 12-08-2013, 07:08 PM
RE: Bang & Olufsen Master de Luxe 39 S - by Arran - 12-09-2013, 01:35 AM
RE: Bang & Olufsen Master de Luxe 39 S - by Arran - 12-11-2013, 01:28 AM
RE: Bang & Olufsen Master de Luxe 39 S - by Arran - 12-14-2013, 02:06 AM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
New Philco Repair Bench
I am sure this is the archive, and not the Chuck's site.morzh — 09:50 PM
Made mistake & did not label connection
It's not like we are good friends with that wire and can tell it from other ptetty identical looking wires. Why'n't you...morzh — 09:49 PM
Made mistake & did not label connection
I'm not sure why that wire wasn't covered in the video. I'm pretty sure the 6A8 won't work until that pin is grounded. Y...RodB — 09:47 PM
Made mistake & did not label connection
You'll have to forgive me, I am not sure what you mean.  Can you explain what you are really saying.  If anyone does not...georgetownjohn — 08:05 PM
Made mistake & did not label connection
Those are details better left to the ones who know. Maybe you disconnected the wrong end of the wire.RodB — 06:22 PM
Made mistake & did not label connection
Maybe this is starting to make some sense in my hard head.  Is this why the wire in question was not in the great Ron Ra...georgetownjohn — 04:34 PM
Made mistake & did not label connection
I was correct with the 6A8 pin connection's, 7 and 8 are connected to ground as well as the tube shield (the broken line...RodB — 02:41 PM
Made mistake & did not label connection
What does the dotted line representing that surrounds the tube in the schematic?georgetownjohn — 02:17 PM
Made mistake & did not label connection
Hello John, I have been there either label got lost or was not labeled ! Sincerely Richardradiorich — 02:15 PM
Made mistake & did not label connection
Sorry, it is a Philco 37-640.  Does that help?--Johngeorgetownjohn — 02:14 PM

[-]
Who's Online
There are currently no members online.

>