1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Knight 650 Signal Generator
ke5yum
Junior Member
**
Posts: 41
Threads: 13
Joined: Feb 2013
City: Oklahoma/Texas
#3

12-11-2013, 04:10 PM
Thanks, Tom, but I wonder if the unit is working at all. I've never worked with a SG before, so I am may be asking weird questions.

Should there be any voltages between the leads? My unit shows only .02. BTW, it powers up, light comes on, and there is voltage at the electrolytics and at the tubes.
Find
« Next Oldest | Next Newest »


Messages In This Thread
Knight 650 Signal Generator - by ke5yum - 12-11-2013, 09:18 AM
RE: Knight 650 Signal Generator - by tom.seeger - 12-11-2013, 12:55 PM
RE: Knight 650 Signal Generator - by ke5yum - 12-11-2013, 04:10 PM
RE: Knight 650 Signal Generator - by tom.seeger - 12-11-2013, 07:04 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration