1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Knight 650 Signal Generator
tom.seeger
Junior Member
**
Posts: 32
Threads: 0
Joined: Aug 2013
City: Ontario Canada
#4

12-11-2013, 07:04 PM
No you shouldn't measure anything with a normal DVM. Set the signal generator to 1 MHz and turn on the modulation. Then clip it to a working radio's antenna. You should get a loud tone around the middle of the AM band. Without it clipped to the antenna it should still pick up a signal from the generator, but it will probably be weak.
Find
« Next Oldest | Next Newest »


Messages In This Thread
Knight 650 Signal Generator - by ke5yum - 12-11-2013, 09:18 AM
RE: Knight 650 Signal Generator - by tom.seeger - 12-11-2013, 12:55 PM
RE: Knight 650 Signal Generator - by ke5yum - 12-11-2013, 04:10 PM
RE: Knight 650 Signal Generator - by tom.seeger - 12-11-2013, 07:04 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

[-]
Who's Online
There are currently 7621 online users. [Complete List]
» 1 Member(s) | 7620 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration