Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 37-640 questions.
#4

I moved this thread to Philco Home Radios since it isn't specifically about a cabinet.

The four positions of the off-on-tone control are for four different levels of tone; the tone is supposed to get deeper as the control is switched clockwise.

As for no reception, two questions:

1. Have all paper and electrolytic capacitors been replaced?
2. Do you have a longwire antenna connected (to the far left of the four screws in back)? This can only be five feet or so for testing purposes, but should be much longer for normal use.

--
Ron Ramirez
Ferdinand IN


Messages In This Thread
Philco 37-640 questions. - by OldRestorer - 12-11-2013, 06:49 PM
RE: Philco 37-640 questions. - by Ron Ramirez - 12-11-2013, 06:56 PM
RE: Philco 37-640 questions. - by OldRestorer - 12-11-2013, 09:32 PM
RE: Philco 37-640 questions. - by Ron Ramirez - 12-11-2013, 09:36 PM
RE: Philco 37-640 questions. - by Warren - 12-11-2013, 10:15 PM
RE: Philco 37-640 questions. - by OldRestorer - 12-12-2013, 07:57 AM
RE: Philco 37-640 questions. - by OldRestorer - 12-12-2013, 08:13 AM
RE: Philco 37-640 questions. - by klondike98 - 12-12-2013, 11:14 AM
RE: Philco 37-640 questions. - by OldRestorer - 12-12-2013, 11:39 AM
RE: Philco 37-640 questions. - by klondike98 - 12-12-2013, 11:58 AM
RE: Philco 37-640 questions. - by Arran - 12-12-2013, 10:25 PM
RE: Philco 37-640 questions. - by klondike98 - 12-12-2013, 11:19 PM
RE: Philco 37-640 questions. - by OldRestorer - 12-13-2013, 07:44 AM



Users browsing this thread: 5 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 6168 online users. [Complete List]
» 3 Member(s) | 6165 Guest(s)
AvatarAvatarAvatar

>